Proper study guides for 200-150 DCICN Introducing Cisco Data Center Networking certified begins with preparation products which designed to deliver the by making you pass the 200-150 test at your first time. Try the free right now.

Online Cisco 200-150 free dumps demo Below:

NEW QUESTION 1
If a user of a SIP endpoint registered to an Expresswayconfigured with only the vidoe.com domain physically dials. ''6501'', what alias is presented in the SIP invite message?

  • A. 6501@<ip address of the endpoint
  • B. 6501
  • C. 6501 @<ip address of the Expressway
  • D. 6501@vidoe.com

Answer: C

NEW QUESTION 2
7K-3 and 7k-4 have the following configuration.
Spanning-tree mst 1 priority 24576 Spanning-tree mst configuration name DCICN
revision 2
instance 1 vlan 100-150
Which of the following statements is true about the network?

  • A. 7K-3 is the mst root for VLANs 100-150
  • B. 7k-4 is the mst root for VLANs 100-150
  • C. Both 7k-3 and 7k-4 are the root for VLANs 100-150
  • D. MST is not enabled on 7k-3 and 7k-4

Answer: D

NEW QUESTION 3
VLAN 10 is assigned IP address 10.1.1.1 with subnet mask 255.255.255.0. Which configuration is used to route the IP subnet but not form OSPF neighbors on a Cisco Nexus 7000 switch?
A)
200-150 dumps exhibit
B)
200-150 dumps exhibit
C)
200-150 dumps exhibit
D)
200-150 dumps exhibit

  • A. Option A
  • B. Option B
  • C. Option C
  • D. Option D

Answer: A

NEW QUESTION 4
Which router type is the most trustworthy for a Cisco routing device?

  • A. EIGRP dynamic
  • B. static
  • C. BGP dynamic
  • D. OSPF dynamic

Answer: A

NEW QUESTION 5
Which statement about the HSRP protocol is true?

  • A. Multiple routers in an HSRP group are in an active state, to enable round-robin load balancing of traffic
  • B. In Cisco NX-O
  • C. HSRP is configured to pre-empt by default
  • D. HSRP version 2 is an open standard protocol that is described in RFC 2281
  • E. One router in an HSRP group is in an active stat
  • F. All other routers are in a standby state or listening state

Answer: C

NEW QUESTION 6
Which purpose is a valid reason to change the mode of an interface to a TE Port on a Cisco Nexus 6000 Series switch?

  • A. to connect a third party SAN switch
  • B. to span a Fibre Channel port
  • C. to connect an NP1V switch to an NPV core switch
  • D. to create a VSAN trunk

Answer: D

NEW QUESTION 7
Which is a configuration mode through Crisco Spark that allows Zero Touch Meetings (ZTM) and allows a user to utilize their enterprise phone as the audio or video terminal for Spark calls?

  • A. Call Connector
  • B. Directory Service
  • C. Call Service Connect
  • D. calendar Service

Answer: C

NEW QUESTION 8
Refer to the exhibit.
200-150 dumps exhibit
Which type of port is used to connect an edge switch in NIPV mode to the core switch?

  • A. E
  • B. F
  • C. NP
  • D. TE

Answer: C

NEW QUESTION 9
Which statement is true about the crossconnections between 5k’s and 7k’s in the network?

  • A. VLAN 100 is the native VLAN
  • B. 56 extended VALN are configured in the network
  • C. VLANs 125-150 are allowed on the cross connections between the 7k’s and 5k’s
  • D. VLANs 100-124 are err-disabled on the cross connections between the 7k’s and 5k’s

Answer: C

NEW QUESTION 10
Which statement about First Hop Redundancy Protocols is true?

  • A. They ensure a loop-free logical topology.
  • B. They use multicast to communicate hello messages with each other.
  • C. They ensure a loop-free physical topology.
  • D. They always require a minimum of three IP addresses.

Answer: D

NEW QUESTION 11
Which two descriptions of fibre Channel WWNs are true? (Choose two.)

  • A. 48 bits long
  • B. 64 or 128 bits long
  • C. 96 bits long
  • D. manually configured on each device by an administrator
  • E. allocated to manufacturers by IEEE

Answer: BE

NEW QUESTION 12
Which three addresses are valid forms of an IPv6 Address: 2001:0DB8:0000:FE01:0000:0000:0000:0000? (Choose three.)

  • A. 2001:0DB8:0000:FE01::
  • B. 2001:DB8:0:FE01::
  • C. 2001:0DB8::FE01::
  • D. 2001:DB8:0:FE01:0:0:0:0

Answer: ABD

NEW QUESTION 13
200-150 dumps exhibit
200-150 dumps exhibit
200-150 dumps exhibit
200-150 dumps exhibit
200-150 dumps exhibit
200-150 dumps exhibit
200-150 dumps exhibit
Which statement regarding Cisco Nexus 5000 Series switches is true?

  • A. Cisco Nexus 5000 Series switches operate in r routing mode.
  • B. Cisco Nexus 5000 Series switches operate in FCoE mode.
  • C. Cisco Nexus 5000 Series switches operate in fabric mode.
  • D. Cisco Nexus 5000 Series switches operate in NPV mode.

Answer: C

NEW QUESTION 14
On which two components of a router can a copy of a running-configuration file be saved manually by an engineer for backup purposes? (Choose two.)

  • A. NVRAM
  • B. Flash
  • C. ROM
  • D. RAM
  • E. DRAM

Answer: AB

NEW QUESTION 15
The MAC address table on a Cisco Nexus Series switch is full What Layer 2 network behavior will occur while the network MAC address table remains full?

  • A. The switch will remove all dynamically learned MAC addresses from the table
  • B. Frames with an unknown destination address will be flooded
  • C. All frames will be flooded
  • D. The switch will reset the MAC address table, removing all MAC addresses.

Answer: C

NEW QUESTION 16
Which description of a vFC interface is true?

  • A. It can be associated to more than one VSAN
  • B. It must be bound to an FCoE-enabled Ethernet or EtherChannel interface.
  • C. It can be associated to a private VLAN
  • D. It can be associated to an FCoE VLAN

Answer: B

Explanation: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/fcoe/513_n1_1/b_Cisco_n5k_fcoe_co

NEW QUESTION 17
What is a unique feature of Expressway?

  • A. Persistent content available to room participants.
  • B. Message, meet and calling for cloud-based solutions.
  • C. Advanced video routing on video-only networks.
  • D. Support of unified communications with contact center

Answer: C

NEW QUESTION 18
Which two are Fibre Channel topologies? (Choose two.)

  • A. spine and leaf topology
  • B. port-to-port
  • C. port-to-multipoint
  • D. star topology
  • E. arbirated loop

Answer: BD

NEW QUESTION 19
What are two features of a bridge? (Choose two.)

  • A. Reliable transmission
  • B. Operate at OSI Layer 2
  • C. Operate at OSI Layer 3
  • D. Create multiple broadcast domains
  • E. Create multiple collision domains
  • F. Flood input packets to all ports
  • G. Drop IP packets with invalid destination ports

Answer: BE

Explanation: "- a bridge is a two interfaces device that creates 2 collision domains, since it forwards the traffic it receives from one interface only to the interface where the destination layer 2 device (based on his mac address) is connected to. A bridge is considered as an "intelligent hub" since it reads the destination mac address in order to forward the traffic only to the interface where it is connected"
https://learningnetwork.cisco.com/thread/1734

100% Valid and Newest Version 200-150 Questions & Answers shared by Surepassexam, Get Full Dumps HERE: https://www.surepassexam.com/200-150-exam-dumps.html (New 177 Q&As)