Cause all that matters here is passing the Cisco 200 310 dumps exam. Cause all that you need is a high score of 200 310 pdf Designing for Cisco Internetwork Solutions exam. The only one thing you need to do is downloading Exambible ccda 200 310 dump exam study guides now. We will not let you down with our money-back guarantee.
Q41. Which routing protocol classification should you use when full topology information is needed?
A. link-state
B. distance vector
C. stateful
D. path vector
Answer: A
Q42. Which option is a benefit of the modular approach to network design?
A. higher availability
B. repeatable scalability
C. increased security
D. improved resiliency
Answer: B
Q43. You need to connect to a remote branch office via an Internet connection. The remote office does not use Cisco equipment. This connection must be secure and must support OSPF. Which of the following can be used to transport data to the branch office?
A. GRE over IPsec
B. IPsec
C. GRE
D. IPsec VTI
Answer: A
Q44. Your supervisor has asked you to deploy a routing protocol within the lab environment that will allow for unequal cost multipath routing. Which should you choose?
A. EIGRP
B. OSPF
C. IS-IS
D. RIP
Answer: A
Q45. You are asked to design a new branch office that will need to support 25 users. These users will be using an ISP connection and will need to connect to the main office for network services..Which two Cisco devices are the most appropriate to fulfill all of these requirements? (Choose two.)
A. Cisco IPS
B. Cisco ISR G2
C. Cisco ASA
D. Cisco 2960
E. Cisco CRS-1
F. Cisco ACS
Answer: B,C
Q46. When designing an EIGRP network, which two things should you take into consideration? (Choose two.)
A. ASN and K values must match.
B. The neighbor command can be used to enable unicast communication.
C. The neighbor diameter cannot exceed a 15-hops limit.
D. NSSA areas can be used to redistribute external routes.
E. Neighbor relationship can be established with non-Cisco routers.
Answer: A,B
Q47. DRAG DROP
Answer:
Q48. Which protocol is used for voice bearer traffic?
A. MGCP
B. RTP
C. SCCP
D. CDP
E. ICMP
Answer: B
Explanation:
VoIP Control and Transport Protocols
A number of different protocols are used in a VoIP environment for call control, device provisioning, and addressing.
Figure 14-15 shows those protocols focused on VoIP control and transport.
Q49. Your company's Cisco routers are operating with EIGRP. You need to join networks with an acquisition's heterogeneous routers at 3 sites, operating with EIGRP and OSPF. Which describes the best practice for routing protocol deployment?
A. Apply OSPF throughout both networks
B. Apply one-way redistribution exclusively at each location
C. Apply two-way redistribution exclusively at each location
D. Apply two-way redistribution at each location with a route filter at only one location
E. Apply two-way redistribution at each location with a route filter at each location
F. Apply EIGRP with the same autonomous system throughout both networks
Answer: E
Explanation: Without filters there is possibility of routing loops.
Link:
http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a008009487e.shtml
Q50. What is the most compact representation of the following IPv6 address?
2001:db8:0000:0000:cafe:0000:0000:1234
A. 2001:db8::cafe::1234
B. 2001:db8::cafe:0000:0000:1234
C. 2001:db8:0:0:cafe::1234
D. 2001:db8::cafe:0:1234
Answer: C