Proper study guides for 300-080 Troubleshooting Cisco IP Telephony and Video certified begins with 300-080 Dumps Questions preparation products which designed to deliver the 300-080 Exam Questions by making you pass the 300-080 test at your first time. Try the free 300-080 Braindumps right now.
Check 300-080 free dumps before getting the full version:
NEW QUESTION 1
For which two reasons does music on holDFail to play? (Choose two.)
- A. The DRAM is corrupted on the Cisco IOS router.
- B. Unicast music on hold is configured and the IP addressing mode is set to IPv4 Only.
- C. A SIP trunk is configured between the phone and the music on hold server.
- D. iPv4 addressing is in use.
- E. Multicast music on hold is configured and the IP addressing mode is set to IPv6 Only.
- F. Analog lines are terminated into the voice gateway.
Answer: EF
NEW QUESTION 2
You configured a Cisco ISR G2 as a SIP gateway, but the gateway does not show that it is registered with Cisco Unified Communications Manager. What is causing this issue?
- A. Cisco Unified Communications Manager does not support SIP gateways.
- B. The gateway does not have the UC license installed.
- C. The gateway does not have Cisco Unified Border Element session licensing.
- D. Cisco Unified Communications Manager does not show a SIP gateway as registered if it is not properly configured.
- E. Cisco Unified Communications Manager never shows a SIP gateway as registereDEven when it is properly configured.
- F. The Cisco ISR G2 cannot be a SIP gateway.
Answer: E
NEW QUESTION 3
Refer to the exhibit.
When the user tried to configure the command maximum sessions 5 under the dspfarm profile 1, the error shown in the exhibit was reported. Which course of action will resolve this issue?
- A. The maximum conference-participants value must be configured >0.
- B. Ensure that the conference bridge is not registered in Cisco Unified Communications Manager.
- C. The command dsp services dspfarm must be configured under the voice-card configuration.
- D. Configure the dspfarm all command under the voice card.
Answer: C
NEW QUESTION 4
Which two statements indicate something that can cause an IP phone to fail roaming when device mobility has been configured? (Choose two.)
- A. Device Mobility Mode is set to Off in the Cisco Unified Communications Manager service parameters while the device mobility configuration on the phone is set to default.
- B. No device mobility groups have been configured.
- C. No locations have been configured and assigned to the device pools.
- D. No physical locations have been configured and assigned to the device pools.
- E. No device mobility-related information settings were configured under the device pools.
Answer: AD
NEW QUESTION 5
Refer to the exhibit.
Intersite calls that are placed across the IP WAN are dialed with the on-net access code 8, followed by the one-digit site code and the four-digit extension of the called party. In order to preserve these dialing habits when the IP WAN is down and Cisco SRST is active, the internal numbers must be converted into E.164 numbers before sending them to the PSTN.
Which configuration allows PSTN calls from the New York site to the San Jose site over the PSTN, while preserving the end user’s six-digit dialing habit?
A)
B)
C)
D)
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: B
NEW QUESTION 6
In a SIP direct call setup, the originating UAC sends what message to the UAS of the recipient?
- A. INVITE
- B. RINGING
- C. ACK
- D. OK
Answer: A
NEW QUESTION 7
Which debug command analyzes messages that are produced by SIP during the call setup process in IOS?
- A. Show isdn status
- B. debug voip ccapi inout
- C. show sip-ua register status
- D. debug isdn q931
- E. debug ccsip messages
- F. debug voice dialpeer
Answer: E
NEW QUESTION 8
Which two troubleshooting tools would initially be the best to use when troubleshooting the PSTN gateway side of a Call routing issue while using Cisco Unified Communications Manager? (Choose two.)
- A. RTMT trace output
- B. Cisco IOS debug commands
- C. Dialed Number Analyzer output
- D. Cisco Unified Communications Manager alerts
- E. Cisco IOS show commands
Answer: BE
NEW QUESTION 9
You implement multiple registrars for SIP trunks for the Cisco Unified Border Element to ensure redundant PSTN access, you fee receive an error that indicates that the registration server is invalid. Which two commands correct the problem? (Choose two.)
- A. registrar 2 ipv4:1.1.1.1 expires 360
- B. CUSP registrar 9 dns:cisco.com expires 60
- C. no registrar 2 dns:cisco.com expires 60
- D. registrar 20 dns:cisco.com
- E. registrar 1 dns:cisco.com expires 180
Answer: AE
NEW QUESTION 10
Refer to the exhibit.
When a Cisco Unified Communications Manager Express advertises the directory number pattern in the
exhibit, what would the learned pattern be in the RTMT tool on the Cisco Unified Communications Manager?
- A. 4XXX and the ToDID will be 0:+1972555
- B. 4XXX and the ToDID will be 0:+19725554XXX
- C. 4XXX and the ToDID will be 0:19725554XXX
- D. 4XXX and the ToDID will be 0:1972555
- E. 19725554XXX and the ToDID will be 0:+1972555
Answer: D
Explanation: The answer is 4XXX and the ToDID will be 0:1972555.
Exhibit explain profile dn-block1 alias-prefix 1972555 and pattern 1 type extension 4xxx.
NEW QUESTION 11
An engineer is analyzing an issue about system connection under Cisco TMS connection, where endpoints handled by TMS automatically change from reachable on LAN to behind the firewall status. Which protocol does the network engineer need to troubleshoot the network between managed device Cisco TMS?
- A. SDP
- B. XMPP
- C. FTP
- D. HTTP
Answer: D
NEW QUESTION 12
A user gets the following error on the IP phone: [205]-User Profile Absent
What could be the probable cause?
- A. The user profile is missing.
- B. The device profile is not attached to the user.
- C. The Enable Extension Mobility option is not enabled in the phone configuration window.
- D. User ID and password are incorrectly entered on the phone.
- E. User is assigned to another phone.
- F. User is logged on to another phone.
Answer: B
NEW QUESTION 13
Where do you configure the phone book provisioning synchronization for an endpoint that is reentered to Cisco VCS?
- A. in Cisco Unified Communications Manager, under the SIP trunk to Cisco VCS
- B. on the Cisco Express C
- C. in the Cisco TelePresence Management suite in the Cisco VCS configuration
- D. on the Cisco VCS Expressway
- E. on the Cisco VCS Control
- F. in the Cisco TelePresence Management Suite under Administration > Provisioning
Answer: F
NEW QUESTION 14
Refer to the exhibit.
A new phone was installed and currently has issues registering with Cisco Unified Communications Manager. The phone received its IP address via DHCP, with options 3 and 150.
Which two actions woulDEnable the phone to download its configuration automatically? (Choose two.)
- A. Change the phone URL parameters to IP addresses.
- B. Provide DHCP option 6 to the phone via DHCP.
- C. Reboot the phone.
- D. Change the VLAN that the phone is assigned to.
- E. Manually assign the phone settings.
- F. Provide DHCP option 15 to the phone via DHCP.
Answer: AB
NEW QUESTION 15
Refer to the exhibit.
a Cisco Unified Communications Manager Extension Mobility enabled user attempts to log in to a new phone where Cisco Extension Mobility Cross Cluster Service is configured with the URL that is displayed in the exhibit. The service is configured on a Cisco Unified CM 9.X or later Unified CM cluster. After the user enters the user ID and PIN, the phone displays “Login is Unavailable (23).”
Which configuration requirement supports Cisco EMCC and avoids this error condition?
- A. The device must be subscribed to Cisco EMCC Services.
- B. The given user ID is not found in the remote cluster.
- C. The user must associate a device profile.
- D. The Cisco IP Phone Services configuration for Cisco EMCC must set the enterprise subscription.
Answer: A
NEW QUESTION 16
In a Cisco Unified Communications Manager call trace, which string indicates an intrasite call?
- A. OutsideDialtone = [1]
- B. cmDeviceType=[AccessDevice]
- C. OutsideDialtone= [0]
- D. OutsideDialtone-[2]
Answer: A
NEW QUESTION 17
Which three items are displayed on the endpoint registration verification page in Cisco VCS? (Choose three.)
- A. E.164 address
- B. endpoint name
- C. endpoint MAC address
- D. endpoint registration status
- E. device description
- F. device type
- G. device pool
Answer: ABF
NEW QUESTION 18
What is the default maximum login time for a user in Cisco Extension Mobility?
- A. 1 hour
- B. 2 hours
- C. 4 hours
- D. 8 hours
- E. 10 hours
- F. 12 hours
- G. 4 hours
- H. 8 hours
- I. 10 hours
- J. 12 hours
- K. 8 hours
- L. 10 hours
- M. 12 hours
- N. 10 hours
- O. 12 hours
- P. 12 hours
Answer: D
NEW QUESTION 19
You enabled Cisco Unified Mobile Connect for a user, but the user is unable to send calls to a mobile phone from the desk phone. What do you do to resolve the issue?
- A. Restart the phone, and verify that the key is present.
- B. Under User Management > User, make sure that the Mobility option is selected.
- C. Make sure that the phone is subscribed to Extension Mobility.
- D. Add the mobility key to the softkey template that the phone is currently using.
Answer: D
Recommend!! Get the Full 300-080 dumps in VCE and PDF From Surepassexam, Welcome to Download: https://www.surepassexam.com/300-080-exam-dumps.html (New 219 Q&As Version)