Guaranteed of 320 300 free exam questions materials and software for Cisco certification for IT learners, Real Success Guaranteed with Updated atr 42 300 320 pdf dumps vce Materials. 100% PASS Designing Cisco Network Service Architectures exam Today!
Q141. A network engineer must provide 40mb connections from the data center to the corporate office and two remote offices. What WAN connectivity option will outsource the routing in cooperation with the service provider?
A. Ethernet Private Line
B. Ethernet Multipoint Service
C. MPLS VPN
D. VPLS
Answer: C
Q142. When a Cisco ASA adaptive security appliance is configured for active/standby failover, which MAC address is used for the active unit?
A. the MAC address of the primary unit
B. the MAC address of the secondary unit
C. the virtual MAC address
D. the standby MAC address
Answer: A
Q143. The direction of the flow of multicast traffic is based on which protocol?
A. PIM
B. IGMP
C. underlying IGP
D. MSDP
Answer: C
Q144. Refer to the exhibit.
Which statement about the ASA is true?
A. The management interface is reachable only from VLAN 30.
B. The management interface is reachable only from VLAN 40.
C. It is running in transparent mode.
D. It is running in routed mode.
Answer: C
Q145. Which option describes why duplicate IP addresses reside on the same network in Cisco network design?
A. HSRP designed network
B. using Cisco ACE in active/passive mode
C. VRRP designed network
D. running multiple routing protocols
Answer: B
Q146. Which two of these correctly describe asymmetric routing and firewalls? (Choose two.)
A. only operational in routed mode
B. only operational in transparent mode
C. only eight interfaces can belong to an asymmetric routing group
D. operational in both failover and non-failover configurations
E. only operational when the firewall has been configured for failover
Answer: C,D
Q147. Which option provides software modularity in Cisco NX-OS software in the data center design?
A. The ip routing command enables all of the features in the Cisco NX-OS.
B. All of the features are enabled by default in the Cisco NX-OS.
C. Individual features must be manually enabled to start the process.
D. The Cisco NX-OS has a management VRF that is enabled by default.
Answer: C
Q148. Which feature must be configured for the VRRP-enabled router to regain the master VRRP status upon recovery from a failure?
A. priority
B. authentication
C. pre-emption
D. Stateful Switchover
Answer: C
Q149. Port security supports which type of port?
A. SPAN destination port
B. EtherChannel port-channel port
C. nonnegotiating trunk port
D. DTP-enabled trunk port
Answer: C
Q150. Which STP enhancement can be configured on Layer 2 ports between distribution layer switches?
A. LoopGuard
B. PortFast
C. UplinkFast
D. RootGuard
Answer: A