Master the 300-620 Implementing Cisco Application Centric Infrastructure (DCACI) content and be ready for exam day success quickly with this Pass4sure 300-620 answers. We guarantee it!We make it a reality and give you real 300-620 questions in our Cisco 300-620 braindumps.Latest 100% VALID Cisco 300-620 Exam Questions Dumps at below page. You can use our Cisco 300-620 braindumps and pass your exam.

Also have 300-620 free dumps questions for you:

NEW QUESTION 1
An engineer has set the VMM resolution immediacy to pre-provision in a Cisco ACI environment. No Cisco Discovery Protocol neighborship has been formed between the hypervisors and the ACI fabric leaf nodes. How does this affect the download policies to the leaf switches?

  • A. No policies are downloaded because LLDP is the only supported discovery protocol.
  • B. Policies are downloaded when the hypervisor host is connected to the VMM VDS.
  • C. Policies are downloaded to the ACI leaf switch regardless of Cisco Discovery Protocol neighborship.
  • D. No policies are downloaded because there is no discovery protocol neighborship.

Answer: C

NEW QUESTION 2
What must be enabled in the bridge domain to have the endpoint table learn the IP addresses of endpoints?

  • A. L2 unknown unicast: flood
  • B. GARP based detection
  • C. unicast routing
  • D. subnet scope

Answer: C

Explanation:
Reference: https://hsvglobalschool.in/dhkycw/cisco-aci-bridge-domain.html

NEW QUESTION 3
A Solutions Architect is asked to design two data centers based on Cisco ACI technology that can extend L2/L3, VXLAN, and network policy across locations. ACI Multi-Pod has been selected. Which two requirements must be considered in this design? (Choose two.)

  • A. ACI underlay protocols, i.
  • B. COOP, IS-IS and MP-BGP, spans across pod
  • C. Create QoS policies to make sure those protocols have higher priority.
  • D. A single APIC Cluster is required in a Multi-Pod desig
  • E. It is important to place the APIC Controllers in different locations in order to maximize redundancy and reliability.
  • F. ACI Multi-Pod requires an IP Network supporting PIM-Bidir.
  • G. ACI Multi-Pod does not support Firewall Clusters across Pod
  • H. Firewall Clusters should always be local.
  • I. Multi-Pod requires multiple APIC Controller Clusters, one per po
  • J. Make sure those clusters can communicate to each other through a highly available connection.

Answer: AE

NEW QUESTION 4
An engineer is extending an EPG out of the ACI fabric using static path binding. Which statement about the endpoints is true?

  • A. Endpoints must connect directly to the ACI leaf port.
  • B. External endpoints are in a different bridge domain than the endpoints in the fabric.
  • C. Endpoint learning encompasses the MAC address only.
  • D. External endpoints are in the same EPG as the directly attached endpoints.

Answer: C

NEW QUESTION 5
Which two dynamic routing protocols are supported when using Cisco ACI to connect to an external Layer 3 network? (Choose two.)

  • A. iBGP
  • B. VXLAN
  • C. IS-IS
  • D. RIPv2
  • E. eBGP

Answer: AE

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/ACI_Best_Practices/b_ACI_Best_Practices/b_ACI_Best_Practices_chapter_010010.html

NEW QUESTION 6
DRAG DROP
Drag and drop the Cisco ACI Layer 4 to Layer 7 service insertion terms on the left to the correct descriptions on the right.
300-620 dumps exhibit

  • A. Mastered
  • B. Not Mastered

Answer: A

Explanation:
300-620 dumps exhibit

NEW QUESTION 7
DRAG DROP
An engineer is configuring a VRF for a tenant named Cisco. Drag and drop the child objects on the left onto the correct containers on the right for this configuration.
300-620 dumps exhibit

  • A. Mastered
  • B. Not Mastered

Answer: A

Explanation:
300-620 dumps exhibit

NEW QUESTION 8
Refer to the exhibit.
300-620 dumps exhibit
An engineer is implementing Cisco ACI – VMware vCenter integration for a blade server that lacks support of bonding. Which port channel mode results in “route based on originating virtual port” on the VMware VDS?

  • A. Static Channel – Mode On
  • B. MAC Pinning-Physical-NIC-load
  • C. LACP Passive
  • D. MAC Pinning+
  • E. LACP Active

Answer: D

NEW QUESTION 9
Which setting prevents the learning of Endpoint IP addresses whose subnet does not match the bridge domain subnet?

  • A. “Limit IP learning to network” setting within the bridge domain.
  • B. “Limit IP learning to subnet” setting within the EPG.
  • C. “Limit IP learning to network” setting within the EPG.
  • D. “Limit IP learning to subnet” setting within the bridge domain.

Answer: D

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/2-x/L2_config/b_Cisco_APIC_Layer_2_Configuration_Guide/b_Cisco_APIC_Layer_2_Configuration_Guide_chapter_010.html

NEW QUESTION 10
Which type of port is used for in-band management within ACI fabric?

  • A. spine switch port
  • B. APIC console port
  • C. leaf access port
  • D. management port

Answer: C

NEW QUESTION 11
An engineer is implementing a connection that represents an external bridged network. Which two configurations are used? (Choose two.)

  • A. Layer 2 remote fabric
  • B. Layer 2 outside
  • C. Layers 2 internal
  • D. Static path binding
  • E. VXLAN outside

Answer: AB

NEW QUESTION 12
What must be configured to redistribute externally learned OSPF routes within the ACI fabric?

  • A. Route Control Profile
  • B. BGP Route Reflector
  • C. BGP Inter-leak Route Map
  • D. PIM Sparse Mode

Answer: B

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/ACI_Best_Practices/b_ACI_Best_Practices/b_ACI_Best_Practices_chapter_010010.html

NEW QUESTION 13
A situation causes a fault to be raised on the APIC. The ACI administrator does not want that fault to be raised because it is not directly relevant to the environment. Which action should the administrator take to prevent the fault from appearing?

  • A. Under System -> Faults, right-click on the fault and select Acknowledge Fault so that acknowledged faults will immediately disappear.
  • B. Create a stats threshold policy with both rising and falling thresholds defined so that the critical severity threshold matches the squelched threshold.
  • C. Under System -> Faults, right-click on the fault and select Ignore Fault to create a fault severity assignment policy that hides the fault.
  • D. Create a new global health score policy that ignores specific faults as identified by their unique fault code.

Answer: C

NEW QUESTION 14
What are two requirements for the IPN network when implementing a Multi-Pod ACI fabric? (Choose two.)

  • A. EIGRP routing
  • B. PIM ASM multicast routing
  • C. BGP routing
  • D. VLAN ID 4
  • E. OSPF routing

Answer: AE

NEW QUESTION 15
An engineer is implementing a Cisco ACI data center network that includes Cisco Nexus 2000 Series 10G fabric extenders. Which physical topology is supported?
A.
300-620 dumps exhibit
B.
300-620 dumps exhibit
C.
300-620 dumps exhibit

  • A. 300-620 dumps exhibit

Answer: D

NEW QUESTION 16
Which two types of interfaces are supported on border leaf switches to connect to an external router? (Choose two.)

  • A. subinterface with VXLAN tagging
  • B. subinterface with 802.1Q tagging
  • C. FEX host interface
  • D. out of band interface
  • E. Switch Virtual Interface

Answer: BE

NEW QUESTION 17
An ACI administrator notices a change in the behavior of the fabric. Which action must be taken to determine if a human intervention introduced the change?

  • A. Inspect event records in the APIC UI to see all actions performed by users.
  • B. Inspect /var/log/audit_messages on the APIC to see a record of all user actions.
  • C. Inspect audit logs in the APIC UI to see all user events.
  • D. Inspect the output of show command history in the APIC CLI.

Answer: A

NEW QUESTION 18
An engineer configured Layer 2 extension from the ACI fabric and changed the Layer 2 unknown unicast policy from Flood to Hardware Proxy. How does this change affect the flooding of the L2 unknown unicast traffic?

  • A. It is forwarded to one of the spines to perform as a spine proxy.
  • B. It is flooded within the whole fabric.
  • C. It is dropped by the leaf when the destination endpoint is not present in the endpoint table.
  • D. It is forwarded to one of the APICs to perform as a proxy.

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/2-x/L2_config/b_Cisco_APIC_Layer_2_Configuration_Guide/b_Cisco_APIC_Layer_2_Configuration_Guide_chapter_010.html

NEW QUESTION 19
In the context of ACI Multi-Site, when is the information of an endpoint (MAC/IP) that belongs to site 1 advertised to site 2 using the EVPN control plane?

  • A. Endpoint information is not exchanged across sites unless COOP protocol is used.
  • B. Endpoint information is not exchanged across sites unless a policy is configured to allow communication across sites.
  • C. Endpoint information is exchanged across sites as soon as the endpoint is discovered in one site.
  • D. Endpoint information is exchanged across sites when the endpoints are discovered in both sites.

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/white-paper-c11-739609.html#CiscoACIMultiSiteoverlaydataplane

NEW QUESTION 20
When configuring Cisco ACI VMM domain integration with VMware vCenter, which object is created in vCenter?

  • A. datacenter
  • B. VMware vSphere Standard vSwitch
  • C. VMware vSphere Distributed Switch
  • D. cluster

Answer: C

NEW QUESTION 21
DRAG DROP
Drag and drop the Cisco ACI filter entry options from the left onto the correct categories on the right indicating what are required or optional parameters.
300-620 dumps exhibit

  • A. Mastered
  • B. Not Mastered

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/Operating_ACI/guide/b_Cisco_Operating_ACI/b_Cisco_Operating_ACI_chapter_01000.html

NEW QUESTION 22
Which description regarding the initial APIC cluster discovery process is true?

  • A. The APIC uses an internal IP address from a pool to communicate with the nodes.
  • B. Every switch is assigned a unique AV by the APIC.
  • C. The APIC discovers the IP address of the other APIC controllers by using Cisco Discovery Protocol.
  • D. The ACI fabric is discovered starting with the spine switches.

Answer: C

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/aci-fundamentals/b_ACI-Fundamentals/b_ACI-Fundamentals_chapter_010011.html

NEW QUESTION 23
Which statement about ACI syslog is true?

  • A. Notifications for different scopes of syslog objects can be sent only to one destination.
  • B. Syslog messages are sent to the destination through the spine.
  • C. All syslog messages are sent to the destination through APIC.
  • D. Switches send syslog messages directly to the destinations.

Answer: A

Explanation:
Reference: https://www.ciscolive.com/c/dam/r/ciscolive/us/docs/2021/pdf/BRKACI-2303.pdf

NEW QUESTION 24
When Cisco ACI connects to an outside Layers 2 network, where does the ACI fabric flood the STP BPDU frame?

  • A. within the bridge domain
  • B. within the APIC
  • C. within the access encap VLAN
  • D. between all the spine and leaf switches

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/white-paper-c07-732033.html#_Toc395143571

NEW QUESTION 25
......

Recommend!! Get the Full 300-620 dumps in VCE and PDF From Thedumpscentre.com, Welcome to Download: https://www.thedumpscentre.com/300-620-dumps/ (New 0 Q&As Version)