We provide real 350-501 exam questions and answers braindumps in two formats. Download PDF & Practice Tests. Pass Cisco 350-501 Exam quickly & easily. The 350-501 PDF type is available for reading and printing. You can print more and practice many times. With the help of our Cisco 350-501 dumps pdf and vce product and material, you can easily pass the 350-501 exam.
Online Cisco 350-501 free dumps demo Below:
NEW QUESTION 1
A customer of an ISP requests support to setup a BGP routing policy. Which BGP attribute should be configured to choose specific BGP speakers as preferred points for the customer AS?
- A. lowest multi-exit discriminator
- B. highest local preference outbound
- C. lowest local preference inbound
- D. highest local preference inbound
Answer: B
NEW QUESTION 2
Refer to the exhibit. When implementing an LDP protocol, an engineer experienced an issue between two directly connected routers and noticed that no LDP neighbor exists for 1.1.1.1. Which factor should be the reason for this situation?
- A. LDP needs to be enabled on the R2 loopback interface.
- B. LDP needs to be enabled on the R2 physical interface.
- C. R2 does not see any hellos from R1.
- D. R2 sees the wrong type of hellos from R1.
Answer: B
NEW QUESTION 3
Which statement about segment routing prefix segments is true?
- A. It is the longest path to a node.
- B. It is linked to an adjacency SID that is globally unique within the router.
- C. It is linked to a prefix SID that is globally unique within segment routing domain.
- D. It requires using EIGRP to operate.
Answer: C
NEW QUESTION 4
Which configuration mode do you use to apply the mpls ldp graceful-restart command in IOS XE Software?
- A. MPLS LDP neighbor
- B. interface
- C. MPLS
- D. global
Answer: D
NEW QUESTION 5
Refer to the exhibit Which effect of this configuration is true?
- A. R1 can support a peer that is configured for LDP SSO/NSF as the peer recovers from an outage.
- B. R1can support a graceful restart operation on the peer, even if graceful restart is disabled on the peer.
- C. R1 can failover to any peer.
- D. R1 can failover only to a peer that is configured for LDF SSO/NSF.
Answer: A
NEW QUESTION 6
Egress PE NAT is being used via a single centralized router to provide Internet access to L3VPN customers.
Which description of the NAT operation is true?
- A. The NAT table contains a field to identify the inside VRF of a translation.
- B. Multiple address pools are needed for the same L3VPN because each site has a separate NAT.
- C. The different L3VPNs using the Internet access must not have IP overlaps internally.
- D. Users in different VRFs cannot share the same outside global IP address.
Answer: A
NEW QUESTION 7
Refer to the exhibit. An engineer is preparing to implement link aggregation configuration. Which statement about this configuration is true?
- A. The switch port negotiates an EtherChannel if it receives LACP packets from a connected peer running passive mode.
- B. The switch port actively sends packets to negotiate an EtherChannel using PAgP.
- C. The switch port passively negotiates an EtherChannel if it receives PAgP packets from a connected peer.
- D. The switch port accepts LACP and PAgP packets from a connected peer and negotiate an EtherChannel using the common EtherChannel mode.
Answer: B
NEW QUESTION 8
A network engineer must enable the helper router to terminate the OSPF graceful restart process if it detects any changes in the LSA.
Which command enables this feature?
- A. nsf ietf helper disable
- B. nsf cisco helper disable
- C. nsf ietf helper strict-lsa-checking
- D. nsf cisco enforce global
Answer: A
NEW QUESTION 9
Refer to the exhibit. After implementing a new design for the network, a technician reviews the pictures CLI output as part of the MOP. Which two elements describe what the technician can ascertain from the ImpNull output? (Choose two.)
- A. Ultimate Hop Popping is in use for the prefix displayed.
- B. Penultimate Hop Popping is in use for the prefix displayed.
- C. Label 0 is used for the prefix displayed, but will not be part of the MPLS label stack for packets destined for 192.168.10.10.
- D. Label 3 is in use for the prefix displayed and will be part of the MPLS label stack for packets destined for 192.168.10.10.
- E. Label 0 is used for the prefix displayed and will be part of the MPLS label stack for packets destined for 192.168.10.10.
Answer: BE
NEW QUESTION 10
Refer to the exhibit. If router RA is configured as shown, which IPv4 multicast address space does it use?
- A. 224.0.0.0/8
- B. 225.0.0.0/8
- C. 232.0.0.0/8
- D. 239.0.0.0/8
Answer: C
NEW QUESTION 11
What do Ansible and SaltStack have in common?
- A. They both have agents running on the client machine.
- B. They both can be designed with more than one master server.
- C. They both use DSL configuration language.
- D. They both use YAML configuration language.
Answer: D
NEW QUESTION 12
DRAG DROP
Drag and drop each NAT64 description from the left onto the correct NAT64 type on the right.
Select and Place:
- A. Mastered
- B. Not Mastered
Answer: A
Explanation: 
NEW QUESTION 13
Refer to the exhibit. On R1, which output does the show isis neighbors command generate?
- A.
- B.
- C.
- D.
Answer: A
NEW QUESTION 14
Which three OSPF parameters must match before two devices can establish an OSPF adjacency? (Choose three.)
- A. IP address
- B. subnet mask
- C. interface cost
- D. process ID
- E. area number
- F. hello timer setting
Answer: BEF
NEW QUESTION 15
Which statement describes the advantage of a Multi-Layer control plane?
- A. It provides multivendor configuration capabilities for Layer 3 to Layer 1.
- B. It automatically provisions, monitors, and manages traffic across Layer 0 to Layer 3.
- C. It supports dynamic wavelength restoration in Layer 0.
- D. It minimizes human error configuring converged networks.
Answer: A
NEW QUESTION 16
Refer to the exhibit. This configuration is being applied on an IOS XR router.
Which statement about this configuration is true?
- A. It is used to enable gRPC.
- B. It is used to create a streaming subscription with a 600-second interval.
- C. It is used to set up configuration to poll network data.
- D. It is used to create a streaming subscription with a 60-Second interval.
Answer: D
NEW QUESTION 17
Refer to the exhibit. A network engineer is implementing QoS services. Which two statements about the qos-group keyword on Cisco IOS XR are true? (Choose two.)
- A. It marks packets for end-to-end QoS policy enforcement across the network.
- B. QoS group marking occurs on the ingress.
- C. The QoS group numbering corresponds to priority level.
- D. QoS group can be used in fabric QoS policy as match criteria.
- E. It cannot be used with priority traffic class.
Answer: BD
NEW QUESTION 18
Refer to the exhibit. Which statement supports QPPB implementation?
- A. QPPB policies affect only egress traffic.
- B. QoS policies rely exclusively on BGP attributes to manipulate traffic.
- C. QoS policies are identified in the MPLS forwarding table.
- D. QoS policies use BGP to gain full coverage on the network.
Answer: D
NEW QUESTION 19
Refer to the exhibit. Which statement describes this configuration?
- A. Router 1 has a new data store to collect SNMP information, but configuration must still be done at the CLI only.
- B. Router 1 can be remotely managed by the CLI using Telnet.
- C. Router 1 has its running configuration locked so changes can be made only when the administrator issues a kill session.
- D. Router 1 has a temporary data store where a copy of the running configuration can be manipulated and verified before committing the configuration.
Answer: D
NEW QUESTION 20
Refer to the exhibit. In which way does router R1 operate differently than router R2?
- A. R1 sends LSA types 5 and 7, while R2 sends type 1, 2, and 7 LSAs.
- B. R1 sends LSA type 2 only, while R2 sends type 1 and type 7 LSAs.
- C. R1 sends LSA type 2 only and R2 sends LSA type 1 only.
- D. R1 sends LSA types 1 and 2, while R2 sends type 1,2, and 7 LSAs.
Answer: D
NEW QUESTION 21
Which task must be performed first to implement BFD in an IS-IS environment?
- A. Configure BFD in an interface configuration mode.
- B. Disable Cisco Express Forwarding on all interfaces running routing protocols other than IS-IS.
- C. Configure all IS-IS routers as Level 2 devices.
- D. Configure BFD under the IS-IS process.
Answer: D
NEW QUESTION 22
Refer to the exhibit. An engineer is preparing to implement data plane security configuration. Which statement about this configuration is true?
- A. Router 1 and Router 2 advertise the route to 192.0.2.0 to all BGP peers.
- B. All traffic to 192.168.1.0/24 is dropped.
- C. All traffic is dropped.
- D. Router 1 drops all traffic with a local-preference set to 150.
Answer: A
NEW QUESTION 23
Refer to the exhibit. P3 and PE4 are at the edge of the service provider core and serve as ABR routers. Aggregation areas are on either side of the core. Which statement about the architecture is true?
- A. To support seamless MPLS, the BGP route reflector feature must be disabled.
- B. If each area is running its own IGP, BGP must provide an end-to-end MPLS LSP.
- C. If each area is running its own IGP, the ABR routers must redistribute the IGP routing table into BGP.
- D. To support seamless MPLS, TDP must be used as the label protocol.
Answer: B
NEW QUESTION 24
......
P.S. Thedumpscentre.com now are offering 100% pass ensure 350-501 dumps! All 350-501 exam questions have been updated with correct answers: https://www.thedumpscentre.com/350-501-dumps/ (102 New Questions)