400 101 vce? Tips for success

Q1. How is the MRU for a multilink bundle determined?

A. It is negotiated by LCP.

B. It is manually configured on the multilink bundle.

C. It is manually configured on all physical interfaces of a multilink bundle.

D. It is negotiated by NCP.

E. It is negotiated by IPCP.

Q2. Which three statements describe the characteristics of a VPLS architecture? (choose three)

A. It can suppress the flooding of traffic

B. It forwards Ethernet frames

C. It supports MAC address aging

D. It maps MAC address destinations to IP next hops

E. It conveys MAC address reachability information in a separate control protocol

F. It replicates broadcast and multicast frames to multiple ports

Q3. Which two statements about AAA authentication are true? (Choose two)

A. RADIUS authentication queries the router's local username database.

B. TACASCS+ authentication uses an RSA server to authenticate users.

C. Local user names are case-insensitive.

D. Local authentication is maintained on the router.

E. KRB5 authentication disables user access when an incorrect password is entered.

Q4. Which two statements about EIGRP load balancing are true? (Choose two.)

A. EIGRP supports 6 unequal-cost paths

B. A path can be used for load balancing only if it is a feasible successor

C. EIGRP supports unequal-cost paths by default.

D. Any path in the EIGRP topology table can be used for unequal-cost load balancing.

E. Cisco Express Forwarding is required to load-balance across interfaces.

Q5. Which IPv4 feature can limit indiscriminate flooding of multicast traffic on a VLAN?

A. PIM Snooping

B. IGMP Filtering

C. MLD Filtering

D. IGMP Snooping

Q6. Which statement about the default QoS configuration on a.Cisco switch is true?

A. AII traffic is sent through four egress queues

B. Port trust is enabled

C. The Port CoS value is 0

D. The CoS value of each tagged packet is modified

Q7.

Refer to the exhibit. If R1 contacts the RADIUS server but is unable to find the user name in the server database, how will R1 respond?

A. It will attempt to authenticate the user against the local database

B. It will attempt to contact the TACACS+ server

C. It will prompt the user to enter a new username

D. It will deny the user access

Q8. What is the correct binary equivalent of DSCP value AF41?

A. 101001

B. 100001

C. 100010

D. 001010

Q9. which two statements about MLD are true?(choose two)

A. MLD is a subprotocol of PIMv6

B. When a single link supports multiple interfaces, only one interface is required to send MLD messages

C. MLD is a subprotocol of ICMPv6

D. When a single link supports multiple interfaces, all supported interface are required to send MLD

messages

E. There are three subtypes of MLD query messages

F. The code section in the MD message is sent to 1 by the sender and ignored by receivers

Q10. Which three actions are required when configuration NAT-PT? (choose three.

A. Specify a ::/48 prefix that will map to a MAC address.

B. Specify a::/32 prefix that will map to an IPV6 address.

C. Specify an IPv6-to-IPv4 translation.

D. Enable NAT-PT Globally.

E. Specify a ::/96 prefix that will map to an IPv4 address.

F. Specify an IPv4-to-IPv6 translation.