It is impossible to pass Cisco passleader 400 101 exam without any help in the short term. Come to Ucertify soon and find the most advanced, correct and guaranteed Cisco 400 101 dumps practice questions. You will get a surprising result by our Improve CCIE Routing and Switching (v5.0) practice guides.

P.S. Real 400-101 keys are available on Google Drive, GET MORE: https://drive.google.com/open?id=1GGI_rFzsSx1M95iUGUrA8n3R9FtM_FJK


New Cisco 400-101 Exam Dumps Collection (Question 10 - Question 19)

New Questions 10

Which two protocols are used by the management plane? Choose two?

A. Telnet

B. BGP

C. OSPF

D. ISSU

E. DTP

F. FTP

Answer: A,F



New Questions 11

Refer to the exhibit.

You have configured a VRF named Blue on R1 as shown. Which action must you take to enable uRPF on the R1 interface E1/0?

A. Configure the ip verify Blue unicast source reachable-via rx allow-default command on interface E0/1

B. Configure the ip verify Blue unicast source reachable-via rx allow-default command under the VRF Blue process

C. Configure the ip verify unicast source reachable-via rx allow-default command under the VRF Blue process

D. Configure the ip verify vrf Blue unicast source reachable-via rx allow-default command on interface E0/1

E. Configure the ip verify unicast source reachable-via rx allow-default command on interface E1/0

Answer: E



New Questions 12

What are two differences between IPv6 ISATAP tunneling and IPv6 6to4 tunneling? (Choose two)

A. Only ISATAP tunneling transfers unicast IPv6 packets between .sites.

B. Only 6to4 tunneling requires 2002::/16 addresses. -

C. Only ISATAP tunneling can transfer IPv6 multicast packets.

D. Only ISATAP tunneling transfers unicast IPv6 packets within a site

E. Only 6to4 tunneling transfers unicast IPv6 packets within a site.

Answer: B,D



New Questions 13

router bgp 65500

neighbor LocalSite ebgp-multihop 2

neighbor LocalSite update-source Loopback0 neighbor LocalSite next-hop-self

neighbor LocalSite route-map CheckCommunity in neighbor LocalSite route-map CPodPeer out

route-map CPodPeer permit 10 match as-path 1

route-map CPodPeer permit 20 match as-path 33

route-map CPodPeer deny 30

ip as-path access-list 1 permit ^$

ip as-path access-list 33 permit _65006$

Refer to the exhibit. Considering a stable neighborship has been established with multiple eBGP peers, which routers are advertised by the router?

A. Only BGP routes sourced on this router

B. Only BGP routes from AS 65006

C. BGP routes that passed through AS 65006 and BGP routes sourced on this router

D. All routes

Answer: C



New Questions 14

Which two statements about scheduling multiple IP SLA operations are true?

A. You must configure IP SLA operations before you can schedule a group of operations.

B. The ip sla monitor group schedule command must be configured on the device.

C. You must configure the frequency of each IP SLA operation before it can start.

D. The IP SLA operations must be scheduled at a maximum interval of 30 seconds.

E. Every IP SLA operation in a single group must start at the same time.

Answer: A,C



New Questions 15

Which two statements about VRF-lite are true? (Choose two)

A. An isolated VRF routing table is created for each VRF

B. A single customer VRF can support overlapping IP addresses

C. Multiple ISP customers can be supported on one customer edge device.

D. Two or more VRFs can be assigned to a single Layer 3 interface

E. At least one physical interface must be configured to enable a VRF

Answer: A,B



New Questions 16

Which prefix List Matches and permits all RFC 1918 network 1 0.0.0.0 routes that have subnet marks of /16 trough /24?

A. ip prefix-list foo seq 10 perm it 10.0.0.0/16 le 24.

B. ip prefix-list foo seq 10 permit 10.0.0.0/16 ge 15 le 25.

C. ip prefix-list foo seq 10 perm it 1 0.0.0.0/8 ge 15 le 25.

D. ip prefix-list foo seq 10 permit 10.0.0.0/8 ge 16 le 24.

Answer: D



New Questions 17

Which value does EIGRP use to determine the metric for a summary address?

A. The average of the component metrics

B. A default fixed value

C. The lowest metric among the component routes

D. The highest metric among the component routes

Answer: C



New Questions 18

Exhibit:

Which two statements about this network are true? (Choose two)

A. It allows successful traceroute operations from R3 to R2

B. It allows successful traceroute operation from R1 to R2

C. It generates syslog messages for all discarded packet

D. It is configured with control-plane policing in silent mode

E. It is configured as distributed control-plane services

Answer: B,E



New Questions 19

Refer to the exhibit,

enable secret cisco

username cisco1 password 0 cisco1 aaa new-model

aaa authentication enable default group radius enable aaa authentication login default group radius line

radius-server host 192.168.1.1 auth-port 1812 acct-port 1646 radius-server key cisco4

line con 0 password cisco2 line vty 0 4 password cisco3

If the RADIUS server is inaccessible, which password can the user enter to access user mode during a Telnet session?

A. cisco2

B. cisco4

C. cisco

D. cisco3

E. cisco1

Answer: D



Recommend!! Get the Real 400-101 dumps in VCE and PDF From Allfreedumps, Welcome to download: https://www.allfreedumps.com/400-101-dumps.html (New 427 Q&As Version)