Master the 400-201 CCIE SP Written v4.0 content and be ready for exam day success quickly with this Testking 400-201 rapidshare. We guarantee it!We make it a reality and give you real 400-201 questions in our Cisco 400-201 braindumps.Latest 100% VALID Cisco 400-201 Exam Questions Dumps at below page. You can use our Cisco 400-201 braindumps and pass your exam.
Q9. Refer to the exhibit.
R1 is using the RP that is learned via BSR R1 also has a static RP configuration in place.
In order to prefer the static RP over BSR, which configuration should be applied on R1?
A. ip pim bsr-candidate loopback 0 priority 200
B. ip pim rp-address 172.1.224.3 priority 200
C. ip pim bsr-candidate loopback 0 override
D. ip pim rp-address 172.1.224.3 override
Answer: D
Q10. Which two flexible service mapping features that are used on the ES40 line card can classify traffic into different service instances, in order to consume fewer VLANs? (Choose two.)
A. CoS
B. DSCP
C. IP precedence
D. MPLS experimental bit
E. ToS
F. EtherType
Answer: A,F
Explanation:
Reference: http://www.cisco.com/c/en/us/td/docs/routers/7600/install_config/ES40_config_guide/es40_ sw_config/es40_chap7.html#pgfId-1500091
Q11. What are the four key design requirements for mobile IP backhaul? (Choose four.)
A. X2 interface turning point
B. bandwidth
C. Layer 2 Tunneling
D. native IPv6 support
E. DiffServQoS
F. MPLS-enabled interface
G. network timing distribution and recovery
H. mandatory Layer 3 access up to a cell site
Answer: C,D,G,H
Explanation: http://www.cisco.com/web/about/ac123/ac147/archived_issues/ipj_14-3/143_backhaul.html
Q12. Refer to the exhibit. Which statement is true?
A. This is an inter autonomous unicast route.
B. The BGP MED value is 26.
C. This is an mVPN route.
D. The route target value is 10.1.100.2:3.
E. There is a route reflector in this network.
F. The route did not import this route into the VRF one.
Answer: E
Q13. What are three main characteristics of mLDP that differ from RSVP-TE? (Choose three.)
A. The LSPs are built from tailend to headend.
B. The LSPs are built from headend to tailend.
C. It supports only P2MP LSPs.
D. It supports both P2MP and MP2MP LSPs.
E. Signaling is periodic.
F. No periodic signaling is performed.
Answer: A,D,F
Explanation: http://www.cisco.com/c/dam/en/us/products/ios-nx-os-software/multicast-label-distribution-protocol-mldp/whitepaper_c11-598929_v1.pdf
Q14. Customers connecting to a Service Provider for Internet access are intending to implement redundant peering. The design requirements call for preferring a primary link for both ingress and egress traffic. Secondary links should be used only during primary outages. What two BGP deployment options will accomplish this design goal? (Choose two.)
A. On the router handling the secondary link, advertise routes with a MED value of 0.
B. On the router handling the primary link, set the weight for all incoming routes to be a value of 0.
C. On the router handling the secondary link, advertise all routes with a longer AS-PATH value.
D. On the router handling the primary link, advertise all routes with a longer AS-PATH value.
E. On the router handling the secondary link, set the local preference for all incoming routes to be a value of 0.
Answer: C,E
Q15. The following MPP configuration is applied on RA router: RP/0/RSP0/CPU0:RA#sh running-config control-plane
control-plane
management-plane
inband
interface TenGigE 0/0/0/0
allow SSH peer
address ipv4 5.0.0.0/8
Which two pieces of information are correct in regards to management traffic on RA router? (Choose two)
A. SNMP traps going out on TenGigE 0/0/0/0 interface are dropped.
B. SNMP polling coming through TenGigE 0/0/0/0 interface are dropped.
C. Telnet connections coming through MgmtEth0/RSP0/CPU0/0 interface are accepted.
D. SSH connections coming through TenGigE 0/0/0/0 interface from 5.5.5.5 host are accepted.
E. TACACS traffic going through TenGigE 0/0/0/0 interface are dropped.
Answer: B,D
Q16. Refer to the exhibit.
A CE connected to a service provider has an agreement to use 512Mbps of bandwidth. Which QoS configuration must be modified to ensure that the traffic matches the agreed bandwidth?
A. Apply the same CE QoS configuration on PE on inbound direction.
B. Change the outbound direction of the service-policy to inbound for ingress traffic shaping.
C. Treat the class-default as best-effort by removing the shape average 512000 command
D. Replace the shape keyword with police keyword in both classes
E. Reconfigure the policy-map as a nested policy with the shaping applied as a parent for all child policies
Answer: E