Your success in Alcatel-Lucent 4A0-100 is our sole target and we develop all our 4A0-100 braindumps in a way that facilitates the attainment of this target. Not only is our 4A0-100 study material the best you can find, it is also the most detailed and the most updated. 4A0-100 Practice Exams for Alcatel-Lucent 4A0-100 are written to the highest standards of technical accuracy.
Q89. From the CE perspective, how does a VPLS operate?
A. A VPLS operates as if 2 sites are directly connected by a single cable.
B. A VPLS operates as if multiple sites are connected through a single switched LAN.
C. A VPLS operates as ifmultiplesites are connected through a single router.
D. A VPLSoperatesas if multiple sites are connected through a series of private point-to-point routed connections.
Answer: B
Q90. Which of the following best describes a repeater?
A. A passive device simply used to connect two or more cables. Does not generate or amplify any signals.
B. A device that receives and retransmits a signal out its ports, but does not do any Layer 2 analysis of the data.
C. A device that receives a signal and based on the Layer 2 destination address, makes a decision on which ports the signal should be retransmitted.
D. A device that receives a signal and based on the Layer 3 destination address, makes a decision on which ports the signal should be retransmitted.
Answer: B
Q91. A 24 port Ethernet switch is configured with VLAN 100 on ports 1 - 8, VLAN 200 on ports 9
-
16 and VLAN 300 on ports 17 - 24. Which of the following describes the behavior of the switch when a broadcast frame is received on port 1?
A.
The switch will discard the broadcast frame because there is no specific destination address.
B.
The switch will flood the broadcast frame on all ports on which the switch has seen frames from attached devices
C.
The switch will flood the broadcast frame on ports 2 to 8.
D.
The switch will flood the broadcast frame on all 24 ports.
Answer: C
Q92. Which of the following is a characteristic of the IP layer?
A. Provides an unreliable, connectionless data transmission service.
B. Provides a mechanism for flow control.
C. Verifies the integrity of all received datagrams.
D. Provides services equivalent to the OSI data link layer.
Answer: A
Q93. How many DS-3 frames can be transported in an OC-3 frame?
A. 1
B. 2
C. 3
D. 4
Answer: C
Q94. Which field in the TCP header is used by the receiver to indicate how many segments it can receive?
A. Checksum
B. SYN
C. Destination port
D. Window size
E. MTU
Answer: D
Q95. Based on the network diagram (click on the exhibit),
what is the command to use on R1 to setup a static route to the network on CR1
A. config router static-route 192.168.2.0/24 next-hop 10.2.3.2
B. config router static-route 10.2.3.1 next-hop 192.168.2.0
C. config router static-route 192.168.2.0/24 next-hop 10.2.3.1
D. config router static-route 10.2.3.2 next-hop 192.168.2.0
Answer: C
Q96. A set of tasks that move a packet from its entry into an IP network to itsexit from the IP network. Thisdescribes:
A. IP routing.
B. IP protocol.
C. IP encapsulation.
D. IP tunneling.
Answer: A