Testking offers free demo for 4A0-101 exam. "Alcatel-Lucent Interior Routing Protocols and High Availability", also known as 4A0-101 exam, is a Alcatel-Lucent Certification. This set of posts, Passing the Alcatel-Lucent 4A0-101 exam, will help you answer those questions. The 4A0-101 Questions & Answers covers all the knowledge points of the real exam. 100% real Alcatel-Lucent 4A0-101 exams and revised by experts!
Q1. From the list below select the statements that describe the behavior of link state information aging. (Choose 2)
A. The age for newly created link state information is set to 0 for OSPF and 1200 for IS-IS
B. The age for newly created link state information is set to 1200 for OSPF and 0 for IS-IS
C. The age is incremented or decremented as it is flooded from router to router and as it is held in the topological database.
D. The age is incremented or decremented only as it is held in the topological database and not as it is flooded router to router.
Answer: AC
Q2. What is the default inbound metric for RIP on the Alcatel-Lucent 7750 SR?
A. Whatever the advertised metric happens to be.
B. A value of 1.
C. This must be administratively set as there is no default value.
D. A value of 15.
Answer: B
Q3. Graceful Restart is supported by what IGPs?
A. RIPv1 and RIPv2
B. OSPF
C. IS-IS
D. BGP
Answer: BC
Q4. What command will show the OSPF neighbors, and their status on the Alcatel-Lucent 7750 SR?
A. show ospf neighbors
B. show router ospf neighbors
C. show router ospf adjacency
D. show ospf adjacency
Answer: B
Q5. When an OSPF adjacency is stuck in the "ExchStart" state, what is the most likely cause?
A. The MTU does not match on both interfaces
B. OSPF is not enabled on one of the routers
C. The Router ID is the same on both routers
D. A OSPF Hello has not been received from the neighbor
Answer: A
Q6. The Alcatel-Lucent 7750 SR supports which two of the OSPF area types below?
A. Not So Stubby Areas
B. Level 1 Areas
C. Stub Areas
D. Partially Stubby Areas
Answer: AC
Q7. Which one of the commands below will create a static route to network 2.3.4.0/24 on the Alcatel-Lucent 7750 SR router?
A. static route 2.3.4.0 255.255.255.0 next hop 3.4.5.6
B. static-route next-hop 3.4.5.6 2.3.4.0/24
C. static route 2.3.4.0/24 next hop 3.4.5.6
D. static-route 2.3.4.0/24 next-hop 3.4.5.6
Answer: D
Q8. What are the ways the RID can be created on an Alcatel-Lucent 7750 SR router? (Choose three)
A. From the last 32 bits of the chassis MAC address
B. From the first 32 bits of the chassis MAC address
C. The loopback IP address
D. By using the command "config router ospf rid X.X.X.X"
E. From the system IP address
F. From the highest interface IP address
Answer: ADE