Proper study guides for Leading HUAWEI HCNA-WLAN - Wireless Local Area Network certified begins with HUAWEI H12-311 preparation products which designed to deliver the Approved H12-311 questions by making you pass the H12-311 test at your first time. Try the free H12-311 demo right now.
Online H12-311 free questions and answers of New Version:
NEW QUESTION 1
The indicator used to describe the extent to which the antenna converges on the transmit power is.
- A. Broadband
- B. Power
- C. Gain
- D. Polarity
Answer: C
NEW QUESTION 2
TKIP encryption is more secure than WEP encryption because (Select 3 Answers).
- A. Adopt a longer IV
- B. Added a key distribution mechanism, no longer using a single key
- C. Adopting a more complex encryption algorithm
- D. Using a stronger data verification algorithm
Answer: ABD
NEW QUESTION 3
The following description of the management VLAN is correct.
- A. Mainly responsible for transmitting data when WLAN users access the Internet
- B. PVID VLAN under WLAN ESS interface
- C. Service VLAN under the service set template
- D. Responsible for establishing the CAPWAP tunnel between the AC and the AP.
Answer: D
NEW QUESTION 4
Commonly used RF cables for WLAN systems are (ABC) (Select 3 Answers).
- A. RG-8 jumper
- B. 1/2" (inch) super soft feeder
- C. 1/2" (inch) feeder
- D. 13/8" (inch) feeder
Answer: ABC
NEW QUESTION 5
What is the command to check online users on the AC?
- A. display users all
- B. display user-interface console 0
- C. display local-user
- D. display access-user
Answer: D
NEW QUESTION 6
In the PoE terminology, the PSU is called the Power Supply Unit, which refers to the power supply unit, such as the Ethernet interface of the PoE switch.
- A. True
- B. False
Answer: B
NEW QUESTION 7
Because 802.11a supports the same maximum rate as 802.11g supports, the 802.11a protocol is backward compatible with the 802.11g protocol.
- A. True
- B. False
Answer: B
NEW QUESTION 8
The antenna obtains the gain by means of .
- A. Using a power amplifier in the antenna system
- B. Making the antenna radiation more concentrated
- C. Use high efficiency antenna feeder
- D. Use low standing wave ratio equipment
Answer: B
NEW QUESTION 9
According to the following output, the following statement is correct (Select 3 Answers).
<Quidway> display version
Huawei Versatile Routing Platform Software
VRP (R) software, Version 5.70 (AC6605 V200R001C00) Copyright (C) 2003-2012 Huawei TECH CO., LTD
Quidway AC6605-PWR Routing Switch uptime is 0 week, 1 day, 23 hours, 33 minutes H852V26S 0(Master) : uptime is 0 week, 1 day, 23 hours, 33 minutes
512M bytes DDR Memory 128M bytes FLASH
Check the running status of the AC6605.
- A. display version can see that the VRP version number of today's devices is 5.70.
- B. The equipment has been running continuously for 1 day, 23 hours and 33 minutes.
- C. Currently the device has used 512 Mbytes of system memory.
- D. The total flash size of the device is 128 Mbyte
Answer: ABD
NEW QUESTION 10
What is the area covered by a single AP?
- A. BSA
- B. ESA
- C. SSA
- D. TSA
Answer: A
NEW QUESTION 11
After a wireless user connects to a wireless signal point, they cannot obtain an IP address. What are the possible reasons (Select 2 Answers)?
- A. The DHCP server is not configured in the VLAN where the user is locate
- B. The dhcp-enable command is not configured on the
- C. wlan-ess virtual interface.
- D. The user-specified authentication password is incorrect.
- E. The MAC address of the user device has been added to the blacklis
Answer: AB
NEW QUESTION 12
Spread-spectrum technology is the basis for transmitting wireless data using the ISM band.
- A. True
- B. False
Answer: A
NEW QUESTION 13
Which of the following options is the maximum rate supported by the 802.11g protocol?
- A. 11Mbps
- B. 22Mbps
- C. 54Mbps
- D. 108Mbps
Answer: C
NEW QUESTION 14
What are the QoS service models (Select 3 Answers).
- A. Best Effort model
- B. IntServ model
- C. FIFO model
- D. DiffServ model
Answer: ABD
NEW QUESTION 15
For the AC6605, the following commands can be used to check whether the AP is online.
- A. display ap online all
- B. display ap all
- C. display ap-type all
- D. dispay ap-run-info all
Answer: B
NEW QUESTION 16
The conditions for switching triggers are generally set (Select 2 Answers).
- A. Start the switch after the STA reaches a certain distance from the original AP.
- B. Set the signal strength ratio between the current AP and the neighbor AP, and switch to the threshold.
- C. Check the packet loss rate and start switching when the packet loss rate reaches a certain value.
- D. Start the switch when the network speed is very slow when it is associated with the original A
Answer: BC
NEW QUESTION 17
The maximum number of layers supported by the location topology in Huawei eSight is layer.
- A. 7
- B. 8
- C. 9
- D. 10
Answer: D
NEW QUESTION 18
In a dual-link backup network, what do the APs use to distinguish between the primary AC and the standby AC (Select 3 Answers)?
- A. Priority
- B. AC IP address
- C. AC load situation
- D. AC response AP time
Answer: ABC
NEW QUESTION 19
The basic service set is the basic component of an 802.11 network and consists of a set of workstations that communicate with each other.
- A. True
- B. False
Answer: A
NEW QUESTION 20
The Barker code is an 11-bit sequence (for example, 10110111000), which has advantages in wireless transmission, which can effectively reduce interference, but reduces efficiency.
- A. True
- B. False
Answer: A
NEW QUESTION 21
What are the options that can be configured under sevice-set (Select 3 Answers)?
- A. The SSID string can be configured via ssid xxxx
- B. can be bound to wmm-profile
- C. Can call wlan-ess interface and configure service-vlan
- D. You can configure the forwarding mode as direct-forward or tunnel-forward
Answer: ACD
NEW QUESTION 22
Among the following options, it is not the main purpose of roaming.
- A. Avoid excessive authentication time during roaming, resulting in packet loss or even service interruption.
- B. Ensure user authorization information remains unchanged.
- C. Ensure that the user's IP address is unchanged.
- D. Ensure that the user's network rate is unchange
Answer: D
NEW QUESTION 23
The naming of the "AP6010DN" is incorrect.
- A. AP in AP6010DN is the specific prefix of the AP of the enterprise network.
- B. AP6010DN "601" represents the standard indoor placement type 1st generation
- C. The āDā in the AP6010DN represents that the AP is a dual-band AP and supports the 2.4GHz and 5GHz bands.
- D. "N" in AP6010DN means AP is an 802.11n A
Answer: D
NEW QUESTION 24
The CAPWAP protocol supports both Split Mac and Local Mac modes of operation.
- A. True
- B. False
Answer: A
NEW QUESTION 25
For outdoor long-distance point-to-point backhaul, the antenna of should be selected.
- A. High gain, small lobe width
- B. High gain, large lobe width
- C. Omnidirectional
- D. Low gain, large lobe width
Answer: A
NEW QUESTION 26
On a WDS network, a root AP can connect to multiple leaf APs, but a leaf AP can connect to only one root AP.
- A. True
- B. False
Answer: A
NEW QUESTION 27
Use the display ap all command to view the MAC, type, and running status of an AP.
- A. True
- B. False
Answer: A
NEW QUESTION 28
Which of the following protocols support the 2.4 GHz band (Select 3 Answers)?
- A. 802.11a
- B. 802.11b
- C. 802.11g
- D. 802.11n
Answer: BCD
NEW QUESTION 29
The lobe width is a very important parameter commonly used in directional antennas. It refers to the angle between the antenna and the radiation pattern below the peak dB The width.
- A. 3
- B. 4
- C. 5
- D. 6
Answer: A
NEW QUESTION 30
The following command can be used to configure the port of the Huawei switch to be in hybrid mode.
- A. s wichport hybrid
- B. hybrid enable
- C. port link-type hybrid
- D. port mode hybrid
Answer: C
NEW QUESTION 31
......
P.S. Easily pass H12-311 Exam with 298 Q&As Certleader Dumps & pdf Version, Welcome to Download the Newest Certleader H12-311 Dumps: https://www.certleader.com/H12-311-dumps.html (298 New Questions)