It is more faster and easier to pass the CompTIA N10-006 exam by using Precise CompTIA CompTIA Network+ questuins and answers. Immediate access to the Abreast of the times N10-006 Exam and find the same core area N10-006 questions with professionally verified answers, then PASS your exam with a high score now.
2021 Nov N10-006 testing engine
Q61. A network technician has detected a personal computer that has been physically connected to the corporate network. Which of the following commands would the network technician use to locate this unauthorized computer and determine the interface it is connected to?
A. nbtstat –a
B. show mac address-table
C. show interface status
D. show ip access-list
E. nslookup hostname
Answer: B
Q62. A technician is configuring a managed switch and needs to enable 802.3af. Which of the following should the technician enable?
A. PoE
B. Port bonding
C. VLAN
D. Trunking
Answer: A
Q63. A SQL server needs several terabytes of disk space available to do an uncompressed backup of a database. Which of the following devices would be the MOST cost efficient to use for this backup?
A. iSCSI SAN
B. FCoE SAN
C. NAS
D. USB flash drive
Answer: C
Q64. A network engineer needs to set up a topology that will not fail if there is an outage on a single piece of the topology. However, the computers need to wait to talk on the network to avoid congestions. Which of the following topologies would the engineer implement?
A. Star
B. Bus
C. Ring
D. Mesh
Answer: C
Q65. The administrator's network has OSPF for the internal routing protocol. One port going out to the Internet is congested. The data is going out to the Internet, but queues up before sending. Which of the following would resolve this issue?
Output:
Fast Ethernet 0 is up, line protocol is up
Int ip address is 10.20.130.5/25
MTU 1500 bytes, BW10000 kbit, DLY 100 usec
Reliability 255/255, Tx load 1/255, Rx load 1/255
Encapsulation ospf, loopback not set Keep alive 10
Half duplex, 100Mb/s, 100 Base Tx/Fx
Received 1052993 broadcasts
0 input errors
983881 packets output, 768588 bytes
0 output errors, 0 collisions, 0 resets
A. Set the loopback address
B. Change the IP address
C. Change the slash notation
D. Change duplex to full
Answer: D
Down to date N10-006 exam question:
Q66. Which of the following describes a smurf attack?
A. Attack on a target using spoofed ICMP packets to flood it
B. Intercepting traffic intended for a target and redirecting it to another
C. Spoofed VLAN tags used to bypass authentication
D. Forging tags to bypass QoS policies in order to steal bandwidth
Answer: A
Q67. The management team wants to set up a wireless network in their office but all of their phones operate at the 2.4 GHz frequency. They need a wireless network that would be able to operate at a higher frequency than their phones. Which of following standards should be used?
A. 802.11a
B. 802.11b
C. 802.11g
D. 802.1x
Answer: A
Q68. A network technician has detected duplicate IP addresses on the network. After testing the behavior of rogue DHCP servers, the technician believes that the issue is related to an unauthorized home router. Which of the following should the technician do NEXT in the troubleshooting methodology?
A. Document the findings and action taken.
B. Establish a plan to locate the rogue DHCP server.
C. Remove the rogue DHCP server from the network.
D. Identify the root cause of the problem.
Answer: B
Q69. A technician is helping a SOHO determine where to install the server. Which of the following should be considered FIRST?
A. Compatibility requirements
B. Environment limitations
C. Cable length
D. Equipment limitations
Answer: B
Q70. A network technician has received a help desk ticket indicating that after the new wireless access point was installed, all of the media department's devices are experiencing sporadic wireless connectivity. All other departments are connecting just fine and the settings on the new access point were copied from the baseline. Which of the following is a reason why the media department is not connecting?
A. Wrong SSID
B. Rogue access point
C. Placement
D. Channel mismatch
Answer: C