Actualtests NS0-504 Questions are updated and all NS0-504 answers are verified by experts. Once you have completely prepared with our NS0-504 exam prep kits you will be ready for the real NS0-504 exam without a problem. We have Up to the minute Network Appliance NS0-504 dumps study guide. PASSED NS0-504 First attempt! Here What I Did.

Q65. Which command on a NetApp storage controller will display the average latency time on a per LUN basis every five seconds?

A. sysstat -i 5

B. sysstat -f 5

C. fcp stats -i 5

D. lun stats -i 5

Answer: D


Q66. In a tape environment after a SnapRestore reversion of a volume, incremental backup and restoreoperations on the file or volume cannot rely on the timestamps to determine what data needs to be backed up or restored. Which course of action ensures correct incremental backups?

A. Perform a base-level backup of the volume after you restore it.

B. Reboot the storage system to reset timestamps back to their original times before the reversion.

C. Take a new snapshot of the volume to create new base-level timestamps for the incremental backup.

D. Take a new snapshot of the volume to create new base-level timestamps for the incremental backup, and then perform a base-level backup of the volume after you restore it.

Answer: A


Q67. Host multi-pathing describes a ___________ solution that has at least two distinct ___________ paths to a LUN.

A. Token ring, physical

B. FC SAN, virtual

C. FC or IP SAN, virtual

D. FC or IP SAN, Physical

Answer: D


Q68. You can avoid data corruption when you issue the cf forcetakeover -d command if the remote node is ________.

A. in a giveback mode

B. fenced off manually

C. powered on and accessible

D. powered off and inaccessible

Answer: D


Q69. There are three phases of Non Disruptive Volume Movement (NDVM). What is the correct sequence of these phases?

A. Setup Phase, Mirror Phase, Cutover Phase

B. Initialization phase, Copy Phase, Migrate Phase

C. Begin Phase, Move Phase, Complete Phase

D. Setup Phase, Data Copy Phase, Cutover Phase

Answer: D


Q70. Using the output below, a co-worker determined that these are type "Solaris" LUNs. What would your determination be?

lun show -m

LUN pathMapped to LUN ID

---------------------------------------------------

/vol/vol1/lun0 solaris-igroup0 0

/vol/vol1/lun1 solaris-igroup1 0

/vol/vol1/qtree1/lun2 solaris-igroup2 0

/vol/vol1/qtree1/lun3 solaris-igroup3 0

A. These are type "Solaris" LUNs.

B. Not enough information is given here. Run the lun map command to get the information requested.

C. Not enough information is given here. Run the lun show -v command to get the information requested.

D. Not enough information is given here. Run the lun status command to get the information requested.

Answer: C


Q71. UNIX allows file access based on ____________.

A. GID or UID and ACLs.

B. GID or UID and UNIX permissions.

C. NT ACLs and SID.

D. NT ACLs and UNIX permissions.

Answer: B


Q72. Which action will cause a currently in-sync SnapMirror relationship to fall out of sync?

A. Running snapmirror update on the source storage system

B. Running snapmirror release on the source storage system

C. Modifying the /etc/snapmirror.conf file for the relationship on the source storage system

D. Modifying the /etc/snapmirror.conf file for the relationship on the destination storage system

Answer: D