Free of jn0-361 practice materials and practice exam for CompTIA certification for IT candidates, Real Success Guaranteed with Updated jn0-361 pdf dumps vce Materials. 100% PASS Service Provider Routing and Switching, Specialist Exam exam Today!
Also have jn0-361 free dumps questions for you:
NEW QUESTION 1
Click the Exhibit.
Referring to the exhibit, which two statements are true? (Choose two.)
- A. The LSP is protected with link protection.
- B. The last node in the path will not pop the MPLS label.
- C. The last node in the path will pop the MPLS label.
- D. The LSP is protected with fast reroute.
Answer: AC
NEW QUESTION 2
Because of recent network failures, additional circuits have been purchased. In addition, Fast reroute has been configured on critical MPLS LSPs.
When the next failure occurs, which two time intervals will affect fast reroute? (Choose two.)
- A. The amount of time required to reroute the traffic onto the detour
- B. The amount of time to detect a link or node failure
- C. The amount of time required to recalculate the best detour
- D. The amount of time it takes to ping the gateway on the detour link
Answer: AB
NEW QUESTION 3
You are asked to configure and apply a new routing policy to influence routing advertisements received from a specific EBGP peer.
In this scenario, which statement is true?
- A. The new policy should be applied as an export policy for the specific EBGP peer.
- B. The new policy should be applied as an import policy for the specific EBGP peer.
- C. The new policy should be applied as an export for the EBGP group in which the peer is defined.
- D. The new policy should be applied as an import policy for the EBGP group in which the peer is defined.
Answer: B
NEW QUESTION 4
Click the exhibit.
A customer has two VLANs to extend between Site-1 and Site-2. The customer does not want to route the VLANs or renumber the VLANs.
Referring to the exhibit, which two VLAN IDs are egressing the MX Series device towards the optical transport network after translation? (Choose two.)
- A. 500
- B. 501
- C. 201
- D. 200
Answer: AB
NEW QUESTION 5
Which two statements are correct about default BGP route propagation? (Choose two.)
- A. IBGP speakers advertise IBGP-learned routes to other IBGP peers.
- B. EBGP speakers advertise IBGP-learned routes to other EBGP peers by using apolicy.
- C. IBGP speakers advertise EBGP-learned routes to other IBGP peers.
- D. EBGP speakers advertise IBGP-learned routes to other EBGP peers.
Answer: BC
NEW QUESTION 6
Which three statements are true about GRES? (Choose three.)
- A. Kernel information is preserved.
- B. Interface information is preserved.
- C. GRES requires only one RE.
- D. GRES requires redundant REs.
- E. Control plane information is preserved.
Answer: ABD
NEW QUESTION 7
Click the Exhibit.
Your network consists of subnets shown in the exhibit. You are asked to create an aggregate route for Router 1.
What is the appropriate prefix for the aggregate route in this scenario?
- A. 172.42.32.0/20
- B. 172.42.32.0/22
- C. 172.42.32.0/19
- D. 172.42.32.0/21
Answer: C
NEW QUESTION 8
Click the Exhibit.
Referring to the exhibit, what is the result of applying this policy?
- A. The 172.18.1.0/24 prefix will be redistributed into OSPF as an internal route.
- B. The 172.18.1.1/32 prefix will be redistributed into OSPF as an external route.
- C. The 172.18.1.0/24 prefix will be redistributed into OSPF as an external route.
- D. The 172.18.1.1/32 prefix will be redistributed into OSPF as an internal route.
Answer: C
NEW QUESTION 9
Click the Exhibit.
You are receiving the same route prefix from four EBGP neighbors.
Based on the information provided in the exhibit, which route will become active?
- A. Route2
- B. Route3
- C. Route4
- D. Route1
Answer: D
NEW QUESTION 10
Click the exhibit.
You are asked to enable a new BGP connection on R1, which has an existing IPv4 peering with R2. The new peering with R3 will use IPv6.
Referring to the exhibit, which two steps are required to enable the new IPv6 peering? (Choose two.)
- A. Configure an IPv6 address on the appropriate interface.
- B. Configure the rib inet6.0 statement under the BGP group.
- C. Configure an IPv6 neighbor address under the BGP group.
- D. Configure an IPv6 local address under the BGP group.
Answer: AC
NEW QUESTION 11
Which two statements are correct regarding TLVs in IS-IS? (Choose two.)
- A. PDUs contain different TLVs.
- B. TLVs contain different PDUs.
- C. The TLV attributes are type, length, and value.
- D. The TLV attributes are tim
- E. Length, and variable.
Answer: AC
NEW QUESTION 12
You are configuring a default static route using the default preference value. You want to ensure that any static route that you configure in the future will be less preferred than the OSPF routes that are configured on the network.
Which command will accomplish this task?
- A. set protocols ospf preference 6
- B. set routing-options static route <IP address> preference 9
- C. set routing-options static defaults preference 20
- D. set routing-options static defaults passive
Answer: C
NEW QUESTION 13
What is the OSPFv3 router ID?
- A. 0.0.0.0
- B. 192.168.1.1
- C. 2001::1:2
- D. 2001::192.168.1.1
Answer: B
NEW QUESTION 14
Which two fields of a hello packet must match on both routers when forming an OSPF adjacency? (Choose two.)
- A. Hello interval
- B. Designated route
- C. Router priority
- D. Network mask
Answer: AD
NEW QUESTION 15
What are tree types of interfaces that can be used in an MX Series device when implementing a virtual switch routing instance? (Choose three.)
- A. Trunk interface
- B. Access interface
- C. Layer 2 logical interface
- D. GRE tunnel interface
- E. Logical tunnel interface
Answer: ABC
NEW QUESTION 16
Click the Exhibit.
The router with the configuration shown in the exhibit has two interfaces, both of which are operational and can pass traffic. These interfaces are connected to two different routers, both of which are configured for OSPF area 0.0.0.1. The router has received LSAs and can now send traffic into the backbone area.
Which two statements are correct? (Choose two.)
- A. The router is an ASBR.
- B. The router has only a single OSPF adjacency.
- C. The router is an ABR.
- D. The router has two OSPF adjacencies.
Answer: AB
NEW QUESTION 17
You are setting up a new IS-IS adjacency between two devices. The new Level1 adjacency is not establishing.
What would cause this behavior?
- A. The routers support a minimum MTU of 1492 bytes.
- B. The Level 1 routers have mismatched area IDs.
- C. The router ID has not been explicitly configured.
- D. The IP addresses are on different subnets.
Answer: B
NEW QUESTION 18
Click the Exhibit.
Your router has an external peering session to 10.10.25.5 and several internal peers. However, routes learned from EBGP peers are showing up in a hidden state on IBGP peers.
Where would you apply the policy shown in the exhibit to solve this issue?
- A. Apply the next-hop-self as an export policy to the external BGP peers.
- B. Apply the next-hop-self as an import policy to the external BGP peers.
- C. Apply the next-hop-self as an export policy to the internal BGP peers.
- D. Apply the next-hop-self as an import policy to the internal BGP peers.
Answer: C
NEW QUESTION 19
What is required on the egress and ingress devices to transport IPv6 traffic across an IPv4 network?
- A. An IP-IP interface
- B. A TE tunnel interface
- C. A GRE tunnel interface
- D. A 6to 4 tunnel interface
Answer: C
NEW QUESTION 20
Which standards-based election protocol facilities redundancy in a LAN environment by eliminating a single point failure through the use of master and backup routers?
- A. VRRP
- B. BFD
- C. graceful restart
- D. ISSU
Answer: A
NEW QUESTION 21
You asked to deploy a large-scale IS-IS network with multiple areas. In this scenario, which two statements are true? (Choose two.)
- A. The area IDs must be the same for Level 2 routers to from an adjacency.
- B. Level1 routers can from an adjacency with any other Level 1 router.
- C. Level1 routers can from an adjacency with any other Level 2 router.
- D. The area IDs must be the same for Level1 routers to from an adjacency.
Answer: BD
NEW QUESTION 22
Which statement is true regarding default MPLS label handling?
- A. A router that pops a label from a label stack always pushes a new label on the packet
- B. A router that pops a label from a label stack forwards a frame based on the label that was popped.
- C. A router that pops a label from a label stack forwards a frame based on the underlying destination IP address.
- D. A router that pops a label from a label stack applies class of service based on the IP header to ToS bits.
Answer: C
NEW QUESTION 23
What are three label operations that an MPLS-enabled router performs? (Choose three.)
- A. swap
- B. push
- C. pop
- D. insert
- E. rewrite
Answer: ABC
NEW QUESTION 24
......
P.S. Surepassexam now are offering 100% pass ensure jn0-361 dumps! All jn0-361 exam questions have been updated with correct answers: https://www.surepassexam.com/jn0-361-exam-dumps.html (65 New Questions)