Shortcuts To 156-115.77（1 to 8）

Exam Code: 156-115.77 (Practice Exam Latest Test Questions VCE PDF)
Exam Name: Check Point Certified Security Master
Certification Provider: Check Point
Free Today! Guaranteed Training- Pass 156-115.77 Exam.

Q1. - (Topic 6) 

In an HA cluster, you modify the number of cores given to CoreXL on only one member using cpconfig and then issue a reboot. What is the expected ClusterXL status of this 

member when it comes up? 

A. Standby 

B. Ready 

C. Active 

D. Down 

Answer: A 

Q2. - (Topic 1) 

When performing a fwm debug, to which directory are the logs written? 

A. $FWDIR/log 

B. $FWDIR/log/fwm.elg 

C. $FWDIR/conf/fwm.elg 

D. $CPDIR/log/fwm.elg 

Answer: B 

Q3. - (Topic 10) 

Which of these commands can be used to display the IPv6 status? 

A. show ipv6-stat 

B. show ipv6 all 

C. show ipv6 status 

D. show ipv6-status 

Answer: D 

Q4. - (Topic 10) 

In a ClusterXL that uses IPV6 Address, how do you configure the sync interface? 

A. You must configure synchronization interfaces with an IPv4 address only. 

B. If an interface does not require IPv6, only the IPv4 definition address is necessary. 

C. All interfaces configured with an IPv6 address must also have a corresponding IPv4 address. 

D. You must configure synchronization interfaces with an IPv6 address only. 

Answer: A 

Q5. - (Topic 3) 

Each connection allowed by a Security Gateway, will have a real entry and some symbolic link entries in the connections state table. The symbolic link entries point back to the real entry using this: 

A. serial number of the real entry. 

B. 6-tuple. 

C. memory pointer. 

D. date and time of the connection establishment. 

Answer: B 

Explanation: 

C3O3 - ClusterXL 

Q6. - (Topic 4) 

What is the log file that shows the keep alive packets during the debug process? 

A. $FWDIR/log/ikev2.xmll 

B. $FWDIR/log/ike.xmll 

C. $FWDIR/log/ike.elg 

D. $FWDIR/log/vpnd.elg 

Answer: C 

Q7. - (Topic 11) 

Where can you configure Wire mode? 

A. In the gateway object in “Stateful Inspection” 

B. In the VPN community in “Advanced Settings” 

C. In cpconfig 

D. In Global Properties 

Answer: B 

Q8. - (Topic 3) 

In some situations, switches may not play nicely with a Check Point Cluster and it is necessary to change from multicast to broadcast. What command should you invoke to correct the issue? 

A. set ccp broadcast 

B. cphaconf set_ccp broadcast 

C. cpha_conf set ccp broadcast 

D. This can only be changed via GuiDbEdit. 

Answer: B