It is impossible to pass Cisco 105 200 exam without any help in the short term. Come to Pass4sure soon and find the most advanced, correct and guaranteed Cisco ccna 200 105 practice questions. You will get a surprising result by our Renewal ICND2 Interconnecting Cisco Networking Devices Part 2 (ICND2 v3.0) practice guides.

P.S. Breathing 200-105 bootcamp are available on Google Drive, GET MORE: https://drive.google.com/open?id=1zYK40K7kFi-jMIoxBFium4FkX2FixrbS


New Cisco 200-105 Exam Dumps Collection (Question 8 - Question 17)

Q8. Which statement about switch access ports is true?

A. They drop packets with 802.1Q tags.

B. A VLAN must be assigned to an access port before it is created.

C. They can receive traffic from more than one VLAN with no voice support

D. By default, they carry traffic for VLAN 10.

Answer: A

Explanation:

"If an access port receives a packet with an 802.1Q tag in the header other than the access VLAN value, that port drops the packet without learning its MAC source address."


Q9. Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?

A. IETF

B. ANSI Annex D

C. Q9333-A Annex A

D. HDLC

Answer: A

Explanation:

Cisco supports two Frame Relay encapsulation types: the Cisco encapsulation and the

IETF Frame Relay encapsulation, which is in conformance with RFC 1490 and RFC 2427. The former is often used to connect two Cisco routers while the latter is used to connect a Cisco router to a non-Cisco router. You can test with your Cisco router when typing the command Router(config-if)#encapsulation frame-relay ? on a WAN link.

Note: Three LMI options are supported by Cisco routers are ansi, Cisco, and Q933a. They represent the ANSI Annex D, Cisco, and ITU Q933-A (Annex A) LMI types, respectively. HDLC is a WAN protocol same as Frame-Relay and PPP so it is not a Frame Relay encapsulation type.


Q10. A router is running three routing processes: RIP, OSPF, and EIGRP, each configured with default characteristics. Each process learns a route to the same remote network.

If there are no static routes to the destination and none of the routes were redistributed, which route will be placed in the IP routing table?

A. the route learned through EIGRP

B. the route learned through OSPF

C. the route learned through RIP

D. the route with the lowest metric

E. all three routes with the router load balancing

Answer: A

Reference: http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094195.shtml

Administrative distance is the feature that routers use in order to select the best path. Administrative distance defines the reliability of a routing protocol. Each routing protocol is prioritized in order of most to least reliable (believable) with the help of an administrative distance value. Lowest Administrative distance will be chosen first.


Q11. Which feature can you use to restrict SNMP queries to a specific OID tree?

A. a server group

B. a view record

C. a community

D. an access group

Answer: C

Explanation: The Setup SNMP view command can block the user with only access to limited Management Information Base (MIB). By default, there is no SNMP view entry exists. This command is configured at the global configuration mode and first introduced in Cisco IOS Software version 10.3. It works similar to access-list in that if you have any SNMP View on certain MIB trees, every other tree is denied inexplicably. However, the sequence is not important and it goes through the entire list for a match before it stops.


Q12. Which three responses does TACAS+ give while querying. (Choose three)

A. error

B. accept

C. continue

D. persist

E. fault

Answer: A,B,C


Q13. Which Cisco platform can verify ACLs?

A. Cisco Prime Infrastructure

B. Cisco Wireless LAN Controller

C. Cisco APIC-EM

D. Cisco IOS-XE

Answer: C


Q14. Which identification number is valid for an extended ACL?

A. 1

B. 64

C. 99

D. 100

E. 299

F. 1099

Answer: D


Q15. Which routing protocols are compatible with stubs. (Choose two)

A. OSPF

B. EIGRP

C. EGP

D. BGP

E. IS_IS

F. RIP

Answer: A,B


Q16. Which protocol is an open standard protocol framework that is commonly used in VPNs, to provide secure end-to-end communications?

A. RSA

B. L2TP

C. IPsec

D. PPTP

Answer: C

Explanation:

Internet Protocol Security (IPsec) is a technology protocol suite for securing Internet Protocol (IP) communications by authenticating and/or encrypting each IP packet of a communication session. IPsec also includes protocols for establishing mutual authentication between agents at the beginning of the session and negotiation of cryptographic keys to be used during the session.


Q17. Refer to the exhibit.

What address is a feasible successor?

A. 172.16.4.0

B. 10.1.4.4

C. 10.1.2.2

D. 172.16.3.0

Answer: C

Explanation:

The feasible condition states:

u201cTo qualify as a feasible successor, a router must have an AD less than the FD of the current successor routeu201d.

In this case, we see 10.1.2.2 shows an AD less than the current successor of 10.1.4.4


100% Renewal Cisco 200-105 Questions & Answers shared by Certleader, Get HERE: https://www.certleader.com/200-105-dumps.html (New 267 Q&As)