Pinpoint of cisco ccna 200 125 exam topics materials and free demo for Cisco certification for candidates, Real Success Guaranteed with Updated ccna 200 125 study guide pdf dumps vce Materials. 100% PASS CCNA Cisco Certified Network Associate CCNA (v3.0) exam Today!

P.S. Pinpoint 200-125 free demo are available on Google Drive, GET MORE: https://drive.google.com/open?id=1jQmx5oxI6Dh5yoCIPQpEra2L4K5UYNUa


New Cisco 200-125 Exam Dumps Collection (Question 8 - Question 17)

Q8. Which value is used to determine the active router in an HSRP default configuration ?

A. router tracking number

B. router IP address

C. router priority

D. router loopback address

Answer: C


Q9. Which statement describes the effect of the copy run start command on a router in enable mode?

A. The running configuration of the router is savedto NVRAM and used during the boot process.

B. The router reboots and loads the last saved running configuration.

C. A copy of the running configuration of the router is sent by FTP to a designated server.

D. A new running configuration is loaded from flashmemory to the router.

Answer: A


Q10. Which technology can provide security when connection multiple sites across the internet?

A. EBGP

B. DMVPN

C. Site-to-site vpn

D. MPLS

Answer: B


Q11. which configuration command can u apply to a HSRP router so that its local interface becomes active if all other routers in the group fail?

A. no additional config is required

B. standby 1 track ethernet

C. standby 1 preempt

D. standby 1 priority 250

Answer: A


Q12. When a router is unable to find a known route in the routing table, how does it handle the packet?

A. It discards the packet

B. It sends the packet over the route with the best metric

C. It sends the packet to the next hop address

D. It sends the packet to the gateway of last resort

Answer: D


Q13. Which statement about EIGRP on IPv6 device is true?

A. It is configured directly on the interface

B. the configuration uses secondary ip address

C. the neighbors of each deice are directly configured

D. the configuration uses process numbers

Answer: A

Explanation: Explanation/Reference: http://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/113267-eigrp-ipv6-00.html


Q14. Which port security violation mode allows traffic from valid mac address to pass but block traffic from invalid mac address?

A. protect

B. shutdown

C. shutdown vlan

D. restrict

Answer: A


Q15. Which command can you enter to re-enable Cisco Discovery Protocol on a local router after it has been disabled?

A. Router(config)# cdp run

B. Router(config-if)# cdp enable

C. Router(config)# cdp enable

D. Router(config-if)# cdp run

Answer: B

Topic 3, Exam Set 3 (NEW)

218.Refer to exhibit.

Which command can you enter to verify link speed and duplex setting on the interface?

A. router#show ip protocols

B. router#show startup-config

C. router#show line

D. router#show interface gig 0/1

Answer: B


Q16. refer to the exhibit , on R1, which routing protocol is in use on the route to 192.168.10.1?

A. EIGRP

B. OSPF

C. RIP

D. BGP

Answer: A


Q17. which statement about snmpv2 is true ?

A. it requires password at least eight characters in length

B. it requires passwords to be encrypted

C. its privacy algorithms use md5 encryption by default

D. its authentic and privacy algorithms are enabled without default values

Answer: D


100% Renovate Cisco 200-125 Questions & Answers shared by Certifytools, Get HERE: https://www.certifytools.com/200-125-exam.html (New 890 Q&As)