Your success in Cisco cisco ccna 200 125 is our sole target and we develop all our ccna 200 125 pdf braindumps in a way that facilitates the attainment of this target. Not only is our cisco 200 125 study material the best you can find, it is also the most detailed and the most updated. 200 125 ccna book Practice Exams for Cisco CCNA Routing and Switching cisco ccna 200 125 are written to the highest standards of technical accuracy.
P.S. Free 200-125 guidance are available on Google Drive, GET MORE: https://www.slideshare.net/reinigerodp/certleader-200-125examquestionsmaterials
New Cisco 200-125 Exam Dumps Collection (Question 1 - Question 10)
Q1. Which statement about upgrading a cisco ios device with TFTP is True ?
A. The Cisco IOS device must be on the same lan as the TFTP server
B. The operation is performed in passive mode
C. The operation is performed in an unencrypted format
D. The operation is performed in active mode
Answer: A
Q2. What is the benefit of point-to-point leased line ?
A. Low cost
B. Full-mesh capability
C. Flexibillity of design
D. Simply configuration
Answer: D
Q3. which two statements about MPLS are true ?
A. it encapsulates all traffic in an ipv4 header
B. it provides automatic authentication
C. it uses labels to separate and forward customer traffic
D. it can carry multiple protocols, including ipv4 and ipv6
E. it tags customer traffic using 802.1q
Answer: C,D
Q4. Which type of secure MAC address must be configured manually?
A. static
B. dynamic
C. sticky
D. bia
Answer: A
Q5. Which of the following is a security best practice?
A. Use multifactor VPN authentication.
B. Use only commercially licensed software
C. Use only WiFi instead of Ethernet cabling
D. use only solid state hard drives in servers.
Answer: A
Q6. which six-byte field in a basic ethernet frame must be an individual address ?
A. FCS
B. SOF
C. SA
D. DA
Answer: C
Q7. Refer to the exhibit.
After you apply the given configuration to R1, you notice that it failed to enable OSPF Which action can you take to correct the problem?
A. Configure a loopback interface on R1
B. Enable IPv6 unicast routing on R1.
C. Configure an IPv4 address on interface FO/0.
D. Configure an autonomous system number on OSPF.
Answer: C
Q8. Which Two options are features of the extended ping command ?
A. it can send packets from a specified interface or ip address
B. it can resolve the destination host name
C. it can ping multiple hosts at the same time
D. it can count the number of hops to the remote host
E. it can send a specified number of packets
Answer: A,E
Q9. which value must you configure on a device beforee EIGRP For IPV6 Can start Running ?
A. Process ID
B. Router ID
C. Public IP Address
D. Loopback interface
Answer: B
Q10. which two statements about vtp are true ?
A. all switches must be configured with the same VTP domain name
B. all switches must be configured with a unique vtp domain name
C. all switches must be configured to perform trunk negotiation
D. all switches must use the same VTP Version
E. The VTP Server must have the highest revision number in the domain
Answer: A,D
P.S. Easily pass 200-125 Exam with Surepassexam Free Dumps & pdf vce, Try Free: https://www.surepassexam.com/200-125-exam-dumps.html (890 New Questions)