Act now and download your Cisco 200-125 test today! Do not waste time for the worthless Cisco 200-125 tutorials. Download Leading Cisco CCNA Cisco Certified Network Associate CCNA (v3.0) exam with real questions and answers and begin to learn Cisco 200-125 with a classic professional.

2021 Sep 200-125 test preparation

Q41. - (Topic 4) 

Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network. The network administrator connected to router Coffee via the console port, issued the show ip route command, and was able to ping the server. 


Based on the output of the show ip route command and the topology shown in the graphic, what is the cause of the failure? 

A. The network has not fully converged. 

B. IP routing is not enabled. 

C. A static route is configured incorrectly. 

D. The FastEthernet interface on Coffee is disabled. 

E. The neighbor relationship table is not correctly updated. 

F. The routing table on Coffee has not updated . 

Answer: C 


Q42. - (Topic 7) 

Refer to the exhibit. 


The network shown in the diagram is experiencing connectivity problems. Which of the following will correct the problems? (Choose two.) 

A. Configure the gateway on Host A as 10.1.1.1. 

B. Configure the gateway on Host B as 10.1.2.254. 

C. Configure the IP address of Host A as 10.1.2.2. 

D. Configure the IP address of Host B as 10.1.2.2. 

E. Configure the masks on both hosts to be 255.255.255.224. 

F. Configure the masks on both hosts to be 255.255.255.240. 

Answer: B,D 


Q43. CORRECT TEXT - (Topic 7) 


Answer: On the MGT Router: 

Config t 

Router eigrp 12 

Network 192.168.77.0 


Q44. - (Topic 9) 

What are two requirements for an HSRP group? (Choose two.) 

A. exactly one active router 

B. one or more standby routers 

C. one or more backup virtual routers 

D. exactly one standby active router 

E. exactly one backup virtual router 

Answer: A,B 


Q45. - (Topic 2) 

Refer to the exhibit. 


A frame on VLAN 1 on switch S1 is sent to switch S2 where the frame is received on VLAN 2. What causes this behavior? 

A. trunk mode mismatches 

B. allowing only VLAN 2 on the destination 

C. native VLAN mismatches 

D. VLANs that do not correspond to a unique IP subnet 

Answer: C 


200-125 exam answers

Up to the minute 200-125 actual exam:

Q46. - (Topic 4) 

Refer to the exhibit. 


The Lakeside Company has the internetwork in the exhibit. The administrator would like to reduce the size of the routing table on the Central router. Which partial routing table entry in the Central router represents a route summary that represents the LANs in Phoenix but no additional subnets? 

A. 10.0.0.0/22 is subnetted, 1 subnets 

   D 10.0.0.0 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1 

B. 10.0.0.0/28 is subnetted, 1 subnets 

   D 10.2.0.0 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1 

C. 10.0.0.0/30 is subnetted, 1 subnets 

   D 10.2.2.0 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1 

D. 10.0.0.0/22 is subnetted, 1 subnets 

   D 10.4.0.0 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1 

E. 10.0.0.0/28 is subnetted, 1 subnets 

   D 10.4.4.0 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1 

F. 10.0.0.0/30 is subnetted, 1 subnets 

   D 10.4.4.4 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1 

Answer: D 


Q47. - (Topic 4) 

Refer to the exhibit. 


When running OSPF, what would cause router A not to form an adjacency with router B? 

A. The loopback addresses are on different subnets. 

B. The values of the dead timers on the routers are different. 

C. Route summarization is enabled on both routers. 

D. The process identifier on router A is different than the process identifier on router B. 

Answer: B 


Q48. - (Topic 3) 

Refer to the diagram. 


All hosts have connectivity with one another. Which statements describe the addressing scheme that is in use in the network? (Choose three.) 

A. The subnet mask in use is 255.255.255.192. 

B. The subnet mask in use is 255.255.255.128. 

C. The IP address 172.16.1.25 can be assigned to hosts in VLAN1 

D. The IP address 172.16.1.205 can be assigned to hosts in VLAN1 

E. The LAN interface of the router is configured with one IP address. 

F. The LAN interface of the router is configured with multiple IP addresses. 

Answer: B,C,F 


Q49. - (Topic 9) 

Refer to the exhibit. 


What is the effect of the given configuration? 

A. It configures an inactive switch virtual interface. 

B. It configures an active management interface. 

C. It configures the native VLAN. 

D. It configures the default VLAN. 

Answer: A 


Q50. - (Topic 9) 

Which command can you enter to display the hits counter for NAT traffic? 

A. show ip nat statistics 

B. debug ip nat 

C. show ip debug nat 

D. clear ip nat statistics 

Answer: A