We guarantee that you may get the most logical as well as fresh Cisco study resources. Win through the weak aspects as well as pass the Cisco Cisco exam along with high represents under the particular help associated with Cisco 200-355 training materials. Please take steps right currently! Its time to place purchase! You will be on the strategy to Cisco 200-355 certification earlier as well as easier. Your objective of Ucertify 200-355 exam braindumps is usually to make you full prepared for the Cisco 200-355 exam.
2021 Apr 200-355 free draindumps
Q91. Which Cisco AnyConnect module allows you to set the parameters that are needed to connect to the wireless network?
A. NAM
B. DART
C. posture
D. telemetry
Answer: A
Q92. In setting up the wireless network, it is desired that the DHCP server that is configured in WLC1 provides IP addressing to the WLAN. When devices attempt to join the network, they fail to receive an IP address in the range provided by the DHCP server in WLC1, but they do receive an IP address from the DHCP server in SW1. What is causing this issue?
A. The external DHCP server in SW1 will always be the preferred DHCP server and WLC1 will always be the secondary DHCP server in the WLAN.
B. The DHCP server address for SW1 needs to be removed from the DHCP server configuration in WLC1.
C. The primary DHCP server address in WLC1 is incorrect.
D. The primary DHCP server configured in WLC1 is not enabled.
Answer: D
Q93. An engineer assists a user in configuring an Android device for authentication to an IEEE 802.1x EAP WLAN with PEAPv1. The Phase 2 authentication should be configured as which option?
A. LEAP
B. MSCHAPv2
C. TLS
D. TTLS
Answer: B
Q94. Which two statements best describe the LAG configuration between a Cisco WLC and a Cisco Catalyst switch? (Choose two.)
A. The Catalyst switch should be configured for PAgP.
B. The Catalyst switch should be configured only for Layer 2 load balancing.
C. The Catalyst switch should be configured for "on" mode.
D. The Cisco WLC relies on the connected switch to perform the load-balance of traffic.
E. The Cisco WLC aggregates multiple management interfaces into a single virtual interface.
Answer: C,D
Q95. RAG DROP
Answer:
Replace 200-355 free practice exam:
Q96. A network engineer in the GUI of WCS version 7 wants to add an access point to a map. Where can this command be found within the drop-down menu?
A. Monitor > Maps
B. Reports > Maps
C. Monitor > Network Summary
D. Configure > Maps
Answer: A
Q97. Which calculation computes the EIRP of an antenna?
A. EIRP = Tx power (dBm) + Antenna Gain (dBi) - Cable Loss (dB)
B. EIRP= Cable Loss (dB)+ Antenna Gain (dBi) - Tx power (dBm)
C. EIRP = Cable Loss (dB)+ Antenna Gain (dBi) / Tx power (dBm)
D. EIRP = Tx power (dBm) + Antenna Gain (dBi) / Cable Loss (dB)
E. EIRP = Antenna Gain (dBi) - Cable Loss (dB) * Tx power (dBm)
F. EIRP = Tx power (dBm) * Antenna Gain (dBi) / Cable Loss (dB)
Answer: A
Q98. What are two wireless configuration utilities for Apple Mac computers? (Choose two.)
A. AirPort
B. AirPort Extreme
C. AirManager
D. AirManager Supreme
E. AirAssistant Ultimate
Answer: A,B
Q99. What is the IEEE name for a group of access points that are connected by using the Ethernet?
A. ESS
B. BSS
C. IBSS
D. ISS
Answer: A
Q100. A customer cannot access the GUI on the Cisco 5508 Wireless Controller from the management interface due to network failure. Which interface can the customer use to access the WLC GUI until the network issues are resolved?
A. virtual
B. dynamic
C. console port
D. service port
Answer: D