we provide Highest Quality Cisco ccnp dumps 300 101 training which are the best for clearing ccnp 300 101 test, and to get certified by Cisco Implementing Cisco IP Routing. The ccnp routing and switching route 300 101 Questions & Answers covers all the knowledge points of the real cisco 300 101 exam. Crack your Cisco 300 101 vce Exam with latest dumps, guaranteed!
Q61. What is the purpose of the autonomous-system {autonomous-system-number} command?
A. It sets the EIGRP autonomous system number in a VRF.
B. It sets the BGP autonomous system number in a VRF.
C. It sets the global EIGRP autonomous system number.
D. It sets the global BGP autonomous system number.
Answer: A
Explanation:
To configure the autonomous-system number for an Enhanced Interior Gateway Routing
Protocol (EIGRP) routing process to run within a VPN routing and forwarding (VRF) instance, use the
autonomous-system command in address-family configuration mode. To remove the autonomous-system
for an EIGRP routing process from within a VPN VRF instance, use the no form of this command.
autonomous-system autonomous-system-number no autonomous-system autonomous-system-number
Reference: http://www.cisco.com/c/en/us/td/docs/ios/iproute_eigrp/command/reference/ire_book/
ire_a1.htm l#wp1062796
Q62. Which statement is true about the PPP Session Phase of PPPoE?
A. PPP options are negotiated and authentication is not performed. Once the link setup is completed, PPPoE functions as a Layer 3 encapsulation method that allows data to be transferred over the PPP link within PPPoE headers.
B. PPP options are not negotiated and authentication is performed. Once the link setup is completed, PPPoE functions as a Layer 4 encapsulation method that allows data to be transferred over the PPP link within PPPoE headers.
C. PPP options are automatically enabled and authorization is performed. Once the link setup is completed, PPPoE functions as a Layer 2 encapsulation method that allows data to be encrypted over the PPP link within PPPoE headers.
D. PPP options are negotiated and authentication is performed. Once the link setup is completed, PPPoE functions as a Layer 2 encapsulation method that allows data to be transferred over the PPP link within PPPoE headers.
Answer: D
Explanation:
PPPoE is composed of two main phases:
Active Discovery Phase--In this phase, the PPPoE client locates a PPPoE server, called an access concentrator. During this phase, a Session ID is assigned and the PPPoE layer is established.
PPP Session Phase--In this phase, PPP options are negotiated and authentication is performed. Once the
link setup is completed, PPPoE functions as a Layer 2 encapsulation method, allowing data to be transferred over the PPP link within PPPoE headers.
Reference:
http://www.cisco.com/c/en/us/td/docs/security/asa/asa92/configuration/vpn/asa-vpn- cli/vpnpppoe.html
Q63. Refer to the exhibit.
Which command only announces the 1.2.3.0/24 network out of FastEthernet 0/0?
A. distribute list 1 out
B. distribute list 1 out FastEthernet0/0
C. distribute list 2 out
D. distribute list 2 out FastEthernet0/0
Answer: D
Explanation:
Access list 2 is more specific, allowing only 1.2.3.0/24, whereas access list 1 permits all 1.0.0.0/8
networks. This question also asks us to apply this distribute list only to the outbound direction of the fast Ethernet 0/0 interface, so the correct command is "distribute list 2
out FastEthernet0/0."
Q64. Refer to the exhibit. Which statement about the configuration is true?
A. 20 packets are being sent every 30 seconds.
B. The monitor starts at 12:05:00 a.m.
C. Jitter is being tested with TCP packets to port 65051.
D. The packets that are being sent use DSCP EF.
Answer: A
Explanation:
Q65. Refer to the following configuration command.
router (config-line)# ntp master 10
Which statement about this command is true?
A. The router acts as an authoritative NTP clock and allows only 10 NTP client connections.
B. The router acts as an authoritative NTP clock at stratum 10.
C. The router acts as an authoritative NTP clock with a priority number of 10.
D. The router acts as an authoritative NTP clock for 10 minutes only.
Answer: B
Explanation:
Q66. You have been asked to evaluate how EIGRP is functioning in a customer network.
What type of route filtering is occurring on R6
A. Distribute-list using an ACL
B. Distribute-list using a prefix-list
C. Distribute-list using a route-map
D. An ACL using a distance of 255
Answer: A
Explanation: