Your success in Cisco ccnp routing and switching route 300 101 is our sole target and we develop all our ccnp route 300 101 dumps braindumps in a way that facilitates the attainment of this target. Not only is our 300 101 vce study material the best you can find, it is also the most detailed and the most updated. 300 101 route pdf Practice Exams for Cisco CCDP ccnp routing and switching route 300 101 are written to the highest standards of technical accuracy.
P.S. Certified 300-101 paper are available on Google Drive, GET MORE: https://drive.google.com/open?id=1PpU_6uksdH22QCdKrEcnWjPvNnVGXp8m
New Cisco 300-101 Exam Dumps Collection (Question 6 - Question 15)
Question No: 6
Which prefix is matched by the command ip prefix-list name permit 10.8.0.0/16 ge 24 le 24?
A. 10.9.1.0/24
B. 10.8.0.0/24
C. 10.8.0.0/16
D. 10.8.0.0/23
Answer: B
Question No: 7
Which two statements about EVNs are true? (Choose two)
A. VRF using MPLS require a trunk interface that use EVN
B. VRF-Lite requires a trunk interface that uses EVN
C. All EVNs within a trunk interface can share the same IP infrastructure
D. Each EVN within a trunk interface must be configured separately
E. Commands that are specified once under a trunk interface can be inherited by all ENVs
Answer: C,E
Question No: 8
Refer to the exhibit.
You have correctly identified the inside and outside interfaces in the NAT configuration of this device. Which effect of this configuration is true?
A. dynamic NAT
B. static NAT
C. PAT
D. NAT64
Answer: C
Question No: 9
Which two types of authentication does EIGRP offer? (Choose two)
A. TKIP
B. MD5
C. WPA
D. Plain text
Answer: B,D
Explanation: The router uses two types of authentication:
u2711 Simple password authentication (also called plain text authentication)u2014Supported by Integrated System-Integrated System (IS-IS), Open Shortest Path First (OSPF), and Routing Information Protocol Version 2 (RIPv2)
u2711 MD5 authenticationu2014Supported by OSPF, RIPv2, BGP, and EIGRP
Question No: 10
A network engineer is trying to implement broadcast-based NTP in a network and executes the ntp broadcast client command. Assuming that an NTP server is already set up, what is the result of the command?
A. It enables receiving NTP broadcasts on the interface where the command was executed.
B. It enables receiving NTP broadcasts on all interfaces globally.
C. It enables a device to be an NTP peer to another device.
D. It enables a device to receive NTP broadcast and unicast packets.
Answer: A
Question No: 11
A packet capture log indicates that several router solicitation messages were sent from a local host on the IPv6 segment. What is the expected acknowledgment and its usage?
A. Router acknowledgment messages will be forwarded upstream, where the DHCP server will allocate addresses to the local host.
B. Routers on the IPv6 segment will respond with an advertisement that provides an external path from the local subnet, as well as certain data, such as prefix discovery.
C. Duplicate Address Detection will determine if any other local host is using the same IPv6 address for communication with the IPv6 routers on the segment.
D. All local host traffic will be redirected to the router with the lowest ICMPv6 signature, which is statically defined by the network administrator.
Answer: B
Question No: 12
You have been asked to evaluate how EIGRP is functioning in a customer network.
What percent of R1u2021s interfaces bandwidth is EIGRP allowed to use?
A. 10
B. 20
C. 30
D. 40
Answer: B
Question No: 13
Which three TCP enhancements can be used with TCP selective acknowledgments? (Choose three.)
A. header compression
B. explicit congestion notification
C. keepalive
D. time stamps
E. TCP path discovery
F. MTU window
Answer: B,C,D
Question No: 14
CORRECT TEXTYou are a network engineer with ROUTE.com, a small IT company. ROUTE.com has two connections to the Internet; one via a frame relay link and one via an EoMPLS link. IT policy requires that all outbound HTTP traffic use the frame relay link when it is available. All other traffic may use either link. No static or default routing is allowed.
Choose and configure the appropriate path selection feature to accomplish this task. You may use the Test Workstation to generate HTTP traffic to validate your solution.
Answer:
We need to configure policy based routing to send specific traffic along a path that is different from the best path in the routing table.
Here are the step by Step Solution for this:
1) First create the access list that catches the HTTP traffic: R1(config)#access-list 101 permit tcp any any eq www
2) Configure the route map that sets the next hop address to be ISP1 and permits the rest of the traffic:
R1(config)#route-map pbr permit 10 R1(config-route-map)#match ip address 101
R1(config-route-map)#set ip next-hop 10.1.100.2 R1(config-route-map)#exit
R1(config)#route-map pbr permit 20
3) Apply the route-map on the interface to the server in the EIGRP Network: R1(config-route-map)#exit
R1(config)#int fa0/1
R1(config-if)#ip policy route-map pbr R1(config-if)#exit
R1(config)#exit
Explanation:
First you need to configure access list to HTTP traffic and then configure that access list. After that configure the route map and then apply it on the interface to the server in EIGRP network.
Question No: 15
Which three problems result from application mixing of UDP and TCP streams within a network with no QoS? (Choose three.)
A. starvation
B. jitter
C. latency
D. windowing
E. lower throughput
Answer: A,C,E
Recommend!! Get the Certified 300-101 dumps in VCE and PDF From Thedumpscentre, Welcome to download: http://www.thedumpscentre.com/300-101-dumps/ (New 745 Q&As Version)