It is more faster and easier to pass the Cisco 300 101 exam exam by using Verified Cisco ROUTE Implementing Cisco IP Routing questuins and answers. Immediate access to the Most recent ccnp route 300 101 Exam and find the same core area ccnp route 300 101 dumps pdf questions with professionally verified answers, then PASS your exam with a high score now.
P.S. Verified 300-101 paper are available on Google Drive, GET MORE: https://drive.google.com/open?id=1lWZpAR5vb8lOApmzhHWMzXffOPhCR-LL
New Cisco 300-101 Exam Dumps Collection (Question 6 - Question 15)
New Questions 6
Which PPP authentication method sends authentication information in cleartext?
A. MS CHAP
B. CDPCP
C. CHAP
D. PAP
Answer: D
New Questions 7
In IPv6, the interfaces running OSPF can be configured with multiple address prefixes.
Which statement is true about the IPv6 addresses that can be included into the OSPF process?
A. Specific addresses cannot be selected for importation into the OSPF process.
B. Specific addresses can be selected using an ACL.
C. Specific addresses can be selected using a route map.
D. Specific addresses can be selected using a prefix list.
Answer: A
Explanation:
http://www.6deploy.eu/workshops/kenya_20080617/IPv6%20Routing_OSPFv3_MP- BGP.pdf (slide 20, 3rd bullet)
New Questions 8
Which option is one way to mitigate symmetric routing on an active/active firewall setup for TCP-based connections?
A. performing packet captures
B. disabling asr-group commands on interfaces that are likely to receive asymetric traffic
C. replacing them with redundant routers and allowing load balancing
D. disabling stateful TCP checks
Answer: D
New Questions 9
When the tunnel interface is configured in default mode, which statement about routers and the tunnel destination address is true?
A. The router must have a route installed towards the tunnel destination
B. the router must have WCCP redirects enabled inbound from the tunnel destination
C. the router must have cisco discovery protocol enabled on the tunnel to form a CDP neighbor ship with the tunnel destination
D. the router must have redirects enabled outbound towards the tunnel destination
Answer: A
New Questions 10
Refer to the exhibit.
Which statement about this neighbor of R1 is true?
A. OSPFv3 adjacency has been lost, which causes the neighbor to be considered Stale.
B. Aggregate global addresses are always used between IPv6 neighbors.
C. OSPFv3 adjacency will not work between link-local addresses.
D. R1 used ICMP to learn about this neighbor.
Answer: D
Explanation:
ICMP is a ping echo. IPv6 uses ICMP to learn about its neighbor.
New Questions 11
Refer to the exhibit. Based on the output from the show command on RT1 which statement is true?
A. OSPFv3 uses global IPv6 addresses to establish neighbor adjacencies.
B. RT1 has a subnet mask of 64 bits.
C. RT1 has FastEthernet0/0 set as a DR for network type broadcast.
D. OSPFv3 uses Link-local addresses to establish neighbor adjacencies.
E. RT1 does not have a global IPv6 address set on FastEthernet0/0.
F. OSPFv3 uses IPv4 addresses to establish neighbor adjacencies.
Answer: D
Explanation:
OSPFv3 is an updated version of OSPF designed to accommodate IPv6 natively. OSPFv3 uses the multicast address FF02::5 and FF02::6, but like EIGRP it uses its link-local address as the source address in advertisements.
New Questions 12
Refer to the exhibit.
Based upon the configuration, you need to understand why the policy routing match counts are not increasing. Which would be the first logical step to take?
A. Confirm if there are other problematic route-map statements that precede divert.
B. Check the access list for log hits.
C. Check the routing table for 212.50.185.126.
D. Remove any two of the set clauses. (Multiple set clause entries will cause PBR to use the routing table.)
Answer: B
Explanation: Explanation
First we should check the access-list log, if the hit count does not increase then no packets are matched the access-list -> the policy based routing match counts will not increase.
New Questions 13
Which IPv6 address type is seen as the next-hop address in the output of the show ipv6 rip RIPng database command?
A. link-local
B. global
C. site-local
D. anycast
E. multicast
Answer: A
New Questions 14
In which two ways can split horizon issues be overcome in a Frame Relay network environment? (choose two.)
A. Configuring one physical serial interface with Frame Relay to various remote sites.
B. Configure a loopback interface with Frame Relay to various remote sites.
C. Configuring multiple subinterfaces on a single physical interface to various remote sites.
D. Enabling split horizon.
E. Disabling split horizon
Answer: C,E
New Questions 15
An engineer is asked to monitor the availability of the next-hop IP address of 172.16.201.25 every 3 seconds using an ICMP echo packet via an ICMP echo probe. Which two commands accomplish this task? (Choose two.)
A. router(config-ip-sla)#icmp-echo 172.16.201.25 source-interface FastEthernet 0/0
B. router(config-ip-sla-echo)#timeout 3
C. router(config-ip-sla)#icmp-jitter 172.16.201.25 interval 100
D. router(config-ip-sla-echo)#frequency 3
E. router(config-ip-sla)#udp-echo 172.16.201.25 source-port 23
F. router(config-ip-sla-echo)#threshold 3
Answer: A,D
P.S. Easily pass 300-101 Exam with 2passeasy Verified Dumps & pdf vce, Try Free: https://www.2passeasy.com/dumps/300-101/ (436 New Questions)