It is more faster and easier to pass the Cisco 300 101 exam exam by using Validated Cisco ROUTE Implementing Cisco IP Routing questuins and answers. Immediate access to the Most up-to-date ccnp route 300 101 pdf Exam and find the same core area ccnp routing and switching route 300 101 official cert guide questions with professionally verified answers, then PASS your exam with a high score now.
P.S. Validated 300-101 pack are available on Google Drive, GET MORE: https://drive.google.com/open?id=1VVsMJd1T1ylej0aePOIREXo7V31c7pn0
New Cisco 300-101 Exam Dumps Collection (Question 10 - Question 19)
Question No: 10
Which value does a point-to-point GRE tunnel use to identify a peer?
A. MAC address
B. configured multicast address.
C. DLCI
D. IP address
E. VC ID
Answer: D
Question No: 11
Refer to the exhibit.
R1 and R2 belong to the RIP routing domain that includes the networks 10.20.0.0/16 and 10.21.0.0/16. R3 and R4 are performing two-way route redistribution between OSPF and RIP. A network administrator has discovered that R2 is receiving OSPF routes for the networks 10.20.0.0/16 and 10.21.0.0/16 and a routing loop has occurred.
Which action will correct this problem?
A. Apply an inbound ACL to the R2 serial interface.
B. Change the RIP administrative distance on R3 to 110.
C. Configure distribute-lists on R3 and R4.
D. Set the OSPF default metric to 20.
E. Change the OSPF administrative distance on R3 to 110.
Answer: C
Explanation:
Distribute List is Like an access-list, use to deny or permit the routing update to pass through a router/interface. Distribute List allow you apply an access list to a routing updates.
It can be apply on in or out bond of an interface under a routing process. e.g in fig. R1 want to send a routing update to it neighbor, this update will go through from interface S0/0, router will check, is there some Distribute List apply to this interface. If there is a Distribute List which would contain the allow route to pass through this interface.
Question No: 12
Based on the configuration command below, which statement is true? Router(config)#service timestamps log datetime msec
A. All IOS services will indicate the date and time when the service was started.
B. All syslog messages that are generated will indicate the date and time when the event occurred.
C. All IOS services will indicate the date and time when the service was last used.
D. All high-priority syslog messages that are generated will indicate the date and time when the event occurred.
Answer: B
Question No: 13
A network engineer is notified that several employees are experiencing network performance related issues, and bandwidth-intensive applications are identified as the root cause. In order to identify which specific type of traffic is causing this slowness, information such as the source/destination IP and Layer 4 port numbers is required. Which feature should the engineer use to gather the required information?
A. SNMP
B. Cisco IOS EEM
C. NetFlow
D. Syslog
E. WCCP
Answer: C
Question No: 14
When a packet is denied by an IPv6 traffic filter, which additional action does the device perform?
A. It scans the rest of the ACL for a permit entry matching the destination
B. It generates a TCP Fin bit and sends it to the source.
C. A creates a null route for the destination and adds it to the route table
D. It generates an ICMP unreachable message for the frame.
Answer: A
Question No: 15
Which command do you enter to filter only routing updates that are sent through interface GigabitEthernet0/0?
A. Rl(config-if)#passive-interface GigabitEthernet0/0.
B. R1(config-router)#no passive-interface GigabitEthernet0/0
C. R1(config-router)#passive-interface GigabitEthernet0/0
D. R1(config-router)passive-interface default
E. R1(config-if)#passive-interface default
F. R1(config-router)#distribute-list 1 GigabitEthernet0/0 out
Answer: C
Question No: 16
A network administrator is troubleshooting a redistribution of OSPF routes into EIGRP.
router eigrp 1
network 10.0.0.0
!
router ospf 1
network 172.10.0.0 0.0.255.255 area 0
redistribute eigrp 1
Given the exhibited commands, which statement is true?
A. Redistributed routes will have an external type of 1 and a metric of 1.
B. Redistributed routes will have an external type of 2 and a metric of 20.
C. Redistributed routes will maintain their original OSPF routing metric.
D. Redistributed routes will have a default metric of 0 and will be treated as reachable and advertised.
E. Redistributed routes will have a default metric of 0 but will be treated as unreachable and not advertised.
Answer: B
Explanation:
By default, all routes redistributed into OSPF will be tagged as external type 2 (E2) with a metric of 20, except for BGP routes (with a metric of 1).
Note: The cost of a type 2 route is always the external cost, irrespective of the interior cost to reach that route. A type 1 cost is the addition of the external cost and the internal cost used to reach that route.
Question No: 17
Which switching method is used when entries are present in the output of the command show ip cache?
A. fast switching
B. process switching
C. Cisco Express Forwarding switching
D. cut-through packet switching
Answer: A
Topic 2, Layer 2 Technologies
13.Prior to enabling PPPoE in a virtual private dialup network group, which task must be completed?
A. Disable CDP on the interface.
B. Execute the vpdn enable command.
C. Execute the no switchport command.
D. Enable QoS FIFO for PPPoE support.
Question No: 18
Refer to the exhibit.
Which command only announces the 1.2.3.0/24 network out of FastEthernet 0/0?
A. distribute list 1 out
B. distribute list 1 out FastEthernet0/0
C. distribute list 2 out
D. distribute list 2 out FastEthernet0/0
Answer: D
Question No: 19
Which common issue causes intermittent DMVPN tunnel flaps?
A. a routing neighbor reachability issue
B. a suboptimal routing table
C. interface bandwidth congestion
D. that the GRE tunnel to hub router is not encrypted
Answer: A
P.S. Easily pass 300-101 Exam with Dumpscollection Validated Dumps & pdf vce, Try Free: http://www.dumpscollection.net/dumps/300-101/ (487 New Questions)