Q11. A network engineer is viewing the QBSS information in a packet sniff. Which two QBSS characteristics are crucial for successful troubleshooting? (Choose two.) 

A. When only WMM is enabled, information element number 1 QBSS Load information element is sent out in the beacons and probe responses. 

B. When only WMM is enabled, information element number 3 QBSS Load information element is sent out in the beacons and probe responses. 

C. When the client CAC limit is supported, information element number 2 is sent out in the beacons and probe responses on the bg radios. 

D. When the client CAC limit is supported, information element number 1 is sent out in the beacons and probe responses on the bg radios. 

E. When only WMM is enabled, information element number 2 QBSS Load information element is sent out in the beacons and probe responses. 

Answer: D,E 


Q12. A customer has "quiet" wireless clients that use static IP addresses. Which two WLAN configurations are required for these wireless clients to connect properly? (Choose two.) 

A. Disable DHCP address assignment required. 

B. Enable passive client. 

C. Disable allow AAA override. 

D. Enable static IP tunneling. 

E. Disable DHCP server override. 

Answer: A,E 


Q13. What is the default NMSP echo interval between a Mobility Services Engine and Wireless LAN Controller? 

A. 30Seconds 

B. 15 Seconds 

C. 10 Seconds 

D. 60 Seconds 

Answer: B 


Q14. A wireless engineer at a convention center has been asked to provision an SSID that can accommodate 4,000 users during a conference. Which interface group configuration should be used? 

A. One interface with /20 mask 

B. Two interfaces with /21 mask 

C. Four interfaces with /22 mask 

D. Eight interfaces with /23 mask 

Answer: D 


Q15. Scenario 

There is a problem with the East-WLC-2504A. When configuration changes are made to the Employees-East-Wing AP Group that covers the East-Wing, none of the APs receive the updates. Referto the exhibits to determine where the problems are. 

What needs to be changed in the configuration of the East-WLC-2504A controller to restore functionality to the Employees-East-Wing AP Group? (Choose four.) 

A. Change the AP in the Employees-East-Wing AP Group. 

B. Change the IP Address in the east-wing interface. 

C. Change the VLAN Identifier in the east-wing interface. 

D. Enable Dynamic AP Management in the east-wing interface. 

E. Change the Port Number to 2 in the east-wing interface. 

F. Add the Primary Controller and IP address to the 3700-East-Wing AP. 

G. Change the SSID in the Employees-East-Wing AP Group. 

H. Change the Interface/Interface Group In the Employees-East-Wing AP Group. 

Answer: D,F,G,H 


Q16. Refer to Exhibit. 

What two items need to be supported on the VoWLAN phones in order to take full advantage of this WLAN configuration? (Choose two.) 

A. APSD 

B. 802.11a 

C. 802.11e 

D. WMM 

E. 802.11r 

F. SIFS 

Answer: C,D 


Q17. After implementing mDNS gateway, a school's network administrator notices that mDNS wireless printers are available over the whole network. Which feature can the admin use to restrict the printer mDNS advertisements to the AP that the printer is joined to and adjacent APs? 

A. mDNS-AP 

B. SSO 

C. LSS 

D. Priority MAC 

Answer: A 


Q18. RAG DROP 

Drag the QoS values from the left and drop them in the correct descending order of priority on the right. 

Answer: 


Q19. A customer requires wireless traffic from the branch to be routed through the firewall at corporate headquarters. There is a RADIUS server in each branch location. Which FlexConnect state should be used in this scenario? 

A. local authentication and local switching 

B. local authentication and central switching 

C. central authentication and central switching 

D. central authentication and local switching 

Answer: C 


Q20. You have set up FlexConnect APs. For which scenario is Fast Roaming supported, providing the WLAN is mapped to the same VLAN and the client is roaming to an AP on the same Cisco WLC? 

A. central switching with PMK (OKC) between different FlexConnect groups 

B. local switching with Cisco Centralized Key Management within the same FlexConnect group 

C. central switching with Cisco Centralized Key Management between different FlexConnect groups 

D. local switching with PMKID within the same FlexConnect group 

Answer: B