Proper study guides for Avant-garde Cisco Deploying Cisco Wireless Enterprise Networks certified begins with Cisco 300-365 preparation products which designed to deliver the Realistic 300-365 questions by making you pass the 300-365 test at your first time. Try the free 300-365 demo right now.
Q21. A customer has implemented several WLANs in an auditorium utilizing a newly dedicated WLC and is experiencing excessive channel utilization regardless of occupancy. Which action reduces channel utilization without removing SSIDs?
A. Disable MCS data rates 0 through 11.
B. Disable MCS data rates used by 40 MHz channels.
C. Disable data rates that use CCK.
D. Disable VHT data rates.
Answer: C
Q22. Which statement about when you configure FlexConnect APs and you want to set up Cisco Centralized Key Management fast roaming is true?
A. FlexConnect groups are required for Cisco Centralized Key Management fast roaming to work with FlexConnect access points.
B. APs that are in the same FlexConnect group but associated to different WLCs support Cisco Centralized Key Management.
C. Cisco Centralized Key Management fast roaming among FlexConnect and non-FlexConnect access points is supported.
D. The FlexConnect access point must be in standalone mode to support Cisco Centralized Key Management.
Answer: A
Q23. VoWLAN implementation plans for a current mix of existing Cisco Unified Wireless IP Phones 7920G and 7921G to a final migration of Wireless IP Phones 7925G in a single WLAN. What would be the most appropriate WLC WLAN configuration to end with Wireless IP Phones 7925G?
A. 7920 Client CAC = enabled only; Radio Policy = All; WMM = Disabled
B. 7920 AP CAC = enabled only; Radio Policy = All; WMM = Allowed
C. 7920 Client CAC = enabled only; Radio Policy = 802.11a only; WMM = Disabled
D. 7920 AP CAC = enabled only; Radio Policy = 802.11a only; WMM = Allowed
E. 7920 Client CAC = enabled only; Radio Policy = 802.11b/g only; WMM = Disabled
F. 7920 AP CAC = enabled only; Radio Policy = 802.11b/g only; WMM = Allowed
Answer: B
Q24. Which network is connected by default when connecting to the unused Ethernet port of a MAP?
A. the native VLAN that the MAP is connected to
B. the VLAN that is associated with WLAN number 1 in the WLC
C. the native VLAN that the WLC is connected to
D. the VLAN that is associated with the SSID that the MAPs are communicating on
Answer: A
Q25. Which show command will show whether a WLAN is locally or centrally switched on a Cisco Wireless Lan Controller?
A. show ap config general Cisco_AP
B. show wlan wlan_id
C. show flexconnect summary
D. show flexconnect group detail
Answer: B
Q26. A customer has implemented a N+1 high availability plan in a multistory building. All APs on odd numbered floors are set as primary to WLC-A and all APs on even numbered floors are set as primary to WLC-8. Which two problems are likely to arise from this design? (Choose two)
A. inconsistent CleanAir data due to multiple WLCs
B. floor-to-floor bleed-through that causes intercontroller roaming delays
C. AVC inconsistency due to multiple mobility group members
D. legacy device compatibility with multiple WLC configuration that causes disconnects
E. unpredictable AP loading during a WLC failure
Answer: A,C
Q27. Which two methods to discover a controller does a MAP attempt when it boots up? (Choose two.)
A. |f Ethernet and wireless are available, it attempts to discover only via Ethernet.
B. if Ethernet is disconnected, it attempts to connect wirelessly using AWPP.
C. if only wireless is available and it is configured as a MAP, it does not attempt to connect to a WLC.
D. If Ethernet and wireless are available, it uses Ethernet first. If it cannot connect via Ethernet, then it chooses wireless.
E. |f Ethernet is disconnected, it attempts to connect wirelessly using the configured DHCP option.
Answer: A,B
Q28. Refer to Exhibit.
A wireless client is connecting to FlexAPI which is currently working standalone mode. The AAA authentication process is returning the following AVPs:
Tunnel-Private-Group-ld(81): 15 Tunnel-Medium-Type(65):IEEE-802(6) Tunnel-Type(64): VLAN(13)
Which three behaviors will the client experience? (Choose three.)
A. While the AP is in standalone mode, the client will be placed in VLAN 15.
B. While the AP is in standalone mode, the client will be placed in VLAN 10.
C. When the AP transitions to connected mode, the client will be de-authenticated.
D. While the AP is in standalone mode, the client will be placed in VLAN 13.
E. When the AP is in connected mode, the client will be placed in VLAN 13.
F. When the AP transitions to connected mode the client will remain associated.
G. When the AP is in connected mode, the client will be placed in VLAN 15.
H. When the AP is in connected mode, the client will be placed in VLAN 10.
Answer: A,D,E
Q29. An engineer must deploy FlexConnect APs to a site that typically has 300 ms latency to the WLC. Which typical operating mode must the engineer plan on for normal operations?
A. local authentication, local switching
B. central authentication, central switching
C. central authentication, local switching
D. connected mode
Answer: A
Q30. CORRECT TEXT
Scenario
One of your colleagues has setup a test network in the lab to simulate a new building atone of your regional offices. Your team is testing AP failover. Your colleague has requested you to configure the WLCs so that in the event of a loss of one of the WLCsthe other wings APs will fail over to the remaining WLC.
The APs on the East-WLC-2504A should fail over to the West-WLC2-2504A, and the APs on the West-WLC2-2504A should fail over to the East-WLC-2504A.
Set the priority of the APs so the backup controller recognizes the join request from the higher-priority AP and if necessary disassociates a lower-priority AP to provide access to an available port.
Not all menus, tabs and features are supported.
Topology
Answer: