Vivid of 4A0-M01 exam question materials and dumps for Alcatel-Lucent certification for candidates, Real Success Guaranteed with Updated 4A0-M01 pdf dumps vce Materials. 100% PASS Alcatel-Lucent IP/MPLS Mobile Backhaul Transport exam Today!
Q65. Which quality level will the SAR router advertise to its Synchronous Ethernet (SyncE) peers?
A. QL-DNU
B. QL-EEC1
C. QL-SSU-A
D. QL-PRC
E. QL-UNC
Answer: B
Q66. In the Alcatel-Lucent SROS, which command creates the OC-3 path's Administrative Unit (AU)-4 Virtual Container (VC) capacity?
A. configure port 3/1/2 sonet-sdh path au-4
B. configure port 3/1/2 sonet-sdh path sts3
C. configure port 3/1/2 sonet-sdh path tug-3
D. configure port 3/1/2 sonet-sdh path vc-4
Answer: B
Q67. Which command example correctly configures a 7750 Service Router (SR) for Synchronous Ethernet (SyncE) support?
A. configure card 1 mda 1 sync-e
B. configure card 1 ethernet sync-e
C. configure system sync-if-timing sync-e no shutdown
D. configure port 1/1/1 ethernet sync-e no shutdown
Answer: A
Q68. Which timing technique can deliver time of day and phase synchronization information to the base station without concern for Packet Delay Variation (PDV)?
A. Building Integrated Timing Supply (BITS)
B. Global Positioning System (GPS)
C. Adaptive Clock Recovery (ACR)
D. IEEE 1588v2/Precision Time Protocol (PTP)
Answer: B
Q69. Once an IEEE 1588v2/Precision Time Protocol (PTP) v2 clock is configured and turned up, to which state do the ports transit on first in order to wait for announcements from the Master?
A. Initial
B. Listening
C. Slave
D. Un-calibrated
Answer: B
Q70. You wish to configure a secondary static route on MLS1 targeting the CSA1 system interface. The route must forward packets over the secondary route path as shown in the diagram. Given the following:
. BFD must be enabled on the preferred route
. BFD is configured on the interfaces
. The MLS1 router must choose the preferred route in normal operations
Which command example correctly configures the secondary static route on MLS1?
A. configure router static-route 192 0.2.2/32 next-hop 192.0.2.6 bfd-enable
B. configure router static-route 192.0.2.6/32 next-hop 192.0.2.22 bfd-enable
C. configure router static-route 192.0.2.2/32 next-hop 192.0.2.14 precedence 10
D. configure router static-route 192.0.2.2/32 next-hop 192.0.2.22 precedence 10
Answer: D
Q71. Upon initial configuration and turn up, what does this show result indicate about the Multilink Point- to-Point (ML-PPP) bundle's current state?
A. The local or remote Layer 3 interface is operationally down
B. The number of bundle links has dropped below the minimum threshold
C. The remote bundle is administratively shut down
D. PPP Link Control Protocol (LCP) negotiations failed
Answer: A
Q72. Click on the exhibit.
On the OC-3 port, each provisioned channel group contains all available timeslots The command result illustrates which OC-3 port characteristic?
A. On STS1-1,the second VT1.5 in the second VTG is set for IPCP encapsulation
B. On STS1-1,the second DS1 channel group in the second VTG isoperationallyup
C. On STS1-1, the second E1 channel group in the second TUG-2 is operationally up
D. On STS1-1, the second VT2 in the second TUG-2 is set for IPCP encapsulation
Answer: C