Top Quality 640-692 Practice Exam 2021

NEW QUESTION 1
Which address facilitates the routing of packets over an IP network?

• A. MAC
• B. transport
• C. network
• D. physical

Answer: C

NEW QUESTION 2
Which windows-based text editor is preferred when working with a simple text document such as a Cisco configuration?

• A. Microsoft Excel
• B. Microsoft Word
• C. Microsoft Notepad
• D. Microsoft Access

Answer: C

NEW QUESTION 3
Which two of the following statements are true? (Choose two)

• A. Because FTP usually requires authentication, a Cisco router must be configured with the appropriate username and password.
• B. FTP uses UDP as its transport protocol.
• C. The copy running-config ftp: command is used to copy a configuration file from an FTP server to the running configuration.
• D. A router can act as an FTP server.
• E. FTP can be used to load Cisco IOS software to router in ROMMON mode.

Answer: AD

NEW QUESTION 4
Which command sends an echo request packet to the largest host and then waits for an echo response message?

• A. telnet
• B. connect
• C. access
• D. echo
• E. ping

Answer: E

NEW QUESTION 5
Which of the following statements are true?

• A. OEM products that are built for Cisco never get a Cisco logo applied.
• B. The Cisco logo, old or new, can be found on the front bezel of all Cisco rack-mountable or desktop products.
• C. Serial numbers are attached by label on all Cisco field-replaceable parts.
• D. At the network level, the user serial number should be different as the part number.

Answer: B

NEW QUESTION 6
Which two modules can be plugged into internal advanced integration module (AIM) slots on a Cisco router? (Choose two)

• A. Virtual Private Network Module
• B. Intrusion Detection System Module
• C. Packet Voice Digital Signal Processor Module
• D. LAN Switching Module
• E. Voice Interface Module

Answer: AB

NEW QUESTION 7
Which statement about unique local IP addresses is true?

• A. Summarization is not supported.
• B. They require all prefixes to be unique.
• C. Their global IDs are assigned sequentially.
• D. They are routable to the public Internet.

Answer: B

NEW QUESTION 8
Which two commands display the saved configuration file? (Choose two)

• A. show configuration
• B. show file system
• C. show running-config
• D. show startup-config

Answer: AD

NEW QUESTION 9
Which statement describes the effect of the copy run start command on a router in enable mode?

• A. The running configuration of the router is saved to NVRAM and used during the boot process.
• B. The router reboots and loads the last saved running configuration.
• C. A copy of the running configuration of the router is sent by FTP to a designated server.
• D. A new running configuration is loaded from flash memory to the router.

Answer: A

NEW QUESTION 10
What are two ways to open Microsoft Notepad on a Windows-based computer? (Choose two)

• A. Start > Run Enter Notepad and 'Ink OK
• B. Start > Control Panel > Notepad
• C. Start > All Programs > Notepad
• D. Start > All Programs > Accessories > Notepad
• E. Start > All Programs > Microsoft Office > Notepad

Answer: AD

NEW QUESTION 11
Which three of the following describe Fast Ethernet? (Choose three)

• A. 1QBASE-T H B
• B. 100BASE-T
• C. 10-Mb/s speed
• D. 100-Mb/s speed
• E. requires Category 3 or higher UTP cabling
• F. requires Category 5 or higher UTP cabling

Answer: BDF

NEW QUESTION 12
Which command is necessary to permit SSH or Telnet access to a cisco switch that is otherwise configured for these vty line protocols?

• A. transport type all
• B. transport output all
• C. transport preferred all
• D. transport input all

Answer: D

NEW QUESTION 13
Which command initiates copying the saved configuration of a Cisco device to a TFTP server?

• A. copy running-config tftp
• B. copy startup-config tftp
• C. copy tftp running-config
• D. copy tftp startup-config

Answer: B

NEW QUESTION 14
Which three of the following statements are true about a router? (Choose three)

• A. It forwards broadcast frames.
• B. It interconnects multiple networks together.
• C. It chooses the best route for your data to travel.
• D. It manages and analyzes a company's database.
• E. It divides a network into separate broadcast domains.

Answer: BCE

NEW QUESTION 15
Which interface card is an encryption module?

• A. NME-VMSS-16
• B. NME-CUSP-522
• C. AIM-VPN/SSL-3
• D. M-1A-OC3-POM

Answer: C

NEW QUESTION 16
Refer to the exhibit.

Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)

• A. The cable that is connected to S0/0 on RouterA is faulty.
• B. Interface S0/0 on RouterB is administratively down.
• C. Interface S0/0 on RouterA is configured with an incorrect subnet mask.
• D. The IP address that is configured on S0/0 of RouterB is not in the correct subnet.
• E. Interface S0/0 on RouterA is not receiving a clock signal from the CSU/DSU.
• F. The encapsulation that is configured on S0/0 of RouterB does not match the encapsulation that is configured on S0/0 of RouterA.

Answer: EF

NEW QUESTION 17
The enable secret command is used to secure access to which CLI mode?

• A. global configuration mode
• B. privileged EXEC mode
• C. user EXEC mode
• D. auxiliary setup mode

Answer: B

NEW QUESTION 18
What are two ways to open a command prompt session on a Windows-based computer? (Choose two)

• A. Click Start > Control Panel > Command Prompt
• B. Click Start > All Programs > Accessories > Command Prompt
• C. Click Start > All Programs > Command Prompt
• D. Click Start > Ru
• E. Enter cmd and click OK
• F. Click Start > All Programs > Accessories > Communications > Command Prompt

Answer: BD

NEW QUESTION 19
DRAG DROP

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:
The correct answer is: Router(boot)# Router(config-if)# Router(config)# Router#
Rommon> Router>

NEW QUESTION 20
Refer to the exhibit.

Which three statements correctly describe Network Device A? (Choose three.)

• A. With a network wide mask of 255.255.255.128, each interface does not require an IP address.
• B. With a network wide mask of 255.255.255.128, each interface does require an IP address on a unique IP subnet.
• C. With a network wide mask of 255.255.255.0, must be a Layer 2 device for the PCs to communicate with each other.
• D. With a network wide mask of 255.255.255.0, must be a Layer 3 device for the PCs to communicate with each other.
• E. With a network wide mask of 255.255.254.0, each interface does not require an IP address.

Answer: BDE

NEW QUESTION 21
......