Q11. Your customer is an ISP providing service to thousands of end customers. Its main concerns are focused on using up the total number of 4096 VLANs per VDC, wasting an unused block of IP addresses, and IP address management. Which technique will address these concerns? 

A. create a separate VDC to scale VLAN limitation and upgrade to Cisco Nexus 7018 Switch 

B. segment VLANs using secondary IP addresses, which will reduce the management domain 

C. create mapping between the VLAN and VSAN to run FCoE to consolidate VLAN and IP addresses 

D. use PVLANs, which will solve the scalability problem and provide IP address management 

Answer:


Q12. Which two statements are true regarding vPC configuration? (Choose two.) 

A. With vPC, there are no blocked ports. 

B. vPC uses hash-based EtherChannel load balancing. 

C. There are STP-blocked redundant links. 

D. There is VLAN-based load balancing. 

E. There is higher oversubscription. 

Answer: AB 


Q13. A customer is deploying multihop FCoE in its network. Which guideline must the customer follow with respect to VE ports to make this deployment possible? 

A. Auto mode on the vFC interface is supported. 

B. VE-port trunking is supported over FCoE-enabled VLANs. 

C. VE-port interface binding to MAC addresses is supported. 

D. A VE port is disabled for trunk mode by default. 

Answer:


Q14. The installation of a new OTV network connecting two data centers via a service provider LAN has failed verification steps. Which statement explains why certain types of data are not being successfully transferred across the OTV network? 

A. The number of extended VLANs across all configured overlays may be greater than 256. 

B. The number of MAC addresses on either edge device may exceed 4000. 

C. The additional 42-byte OTV overhead, along with the DF bit being set, may cause the service provider to drop packets based on their 1500 MTU settings. 

D. Having more than two edge devices per site is not supported. 

Answer:


Q15. Which command would you use to find the AED of an extended VLAN in a dual-homed site of an OTV network? 

A. show otv aed on the AED 

B. show otv site on any edge devices in the site 

C. show otv vlan on the AED 

D. show otv aed on any edge devices in the site 

E. show otv vlan on any edge devices in the site 

Answer:


Q16. Which two describe the correct requirements for non-disruptive IOS ISSU on Cisco Nexus 7000 Series Switches? (Choose two.) 

A. updated kickstart and system images must be staged in bootflash on single-supervisor switches 

B. updated kickstart and system images must be staged in bootflash on dual-supervisor switches 

C. low version skew 

D. dual supervisors 

E. clock synchronization 

Answer: CD 


Q17. Which command is critical in order for OTV edge devices to maintain an overlay adjacency with their local peers in a multihomed site via the join interfaces across the Layer 3 network domain? 

A. otv site-identifier 

B. otv extend-vlan 

C. otv site-vlan 

D. otv use-adjacency-server unicast-only 

Answer:


Q18. In a Cisco Data center network, what troubleshooting step would you do first when having a npv issue? 

A. Check to see if npv is enable 

B. Check name server database to see if it recognizes device 

C. Check detail config of FCNS database 

D. Check the show-tech-support detail 

Answer:


Q19. Which CLI command can tell which switch is on the other side of port channel 2 that is trunking VSAN 5? 

A. show topology vsan 5 

B. show interface port-channel 2 trunk vsan 5 

C. show interface port-channel 2 vsan 5 peer-info 

D. show fcs vsan 5 

E. show fspf database vsan 5 interface port-channel 2 

Answer:


Q20. Refer to exhibit. 

Customer has a pair of Cisco Nexus7010s switches and connected to a single Cisco Nexus5548 switch via vPC. Customer has a combination of M1 and F1 I/O Modules in Cisco Nexus7010s. 

Why is the design described not supported? 

A. Mixing I/O Modules on the Same Side of a Peer Link is not supported 

B. vPC does not support split control plane 

C. You can not configure a vPC peer link to configure two devices as vPCs 

D. Need to add another Cisco Nexus5548 switch to the topology to make this work. 

Answer: