Latest BICSI RCDD RCDD Latest Exam

NEW QUESTION 1

In new construction, what is the percentage of pay phones that must be equipped with volume controls?

• A. 4
• B. 10
• C. 25
• D. 35
• E. 50

Answer: C

NEW QUESTION 2

At a minimum, convenience receptacles in an ER or TR are to be located ______ AFF.

• A. 150 mm (6 in)
• B. 300 mm (12 in)
• C. 375 mm (15 in)
• D. 450 mm (18 in)

Answer: A

NEW QUESTION 3

What type of estimate is based on the cost of performing similar work in the past, adjusted for current job conditions?

• A. Analogous
• B. Parametric
• C. Engineering
• D. Ledger
• E. PERT

Answer: A

NEW QUESTION 4

The recommended MAXIMUM value for the bonding resistance between the nearest available grounding electrode and the busbar in an entrance facility (EF) is ______ ohms.

• A. 0.1
• B. 0.5
• C. 1
• D. 2
• E. 5

Answer: A

NEW QUESTION 5

What type of address is 00-A1-C3-52-CE-11?

• A. IP
• B. MAC
• C. Host
• D. Broadcast
• E. Unicast

Answer: B

NEW QUESTION 6

During a site survey you notice that several CRT displays in the vicinity of the engineering copy center have sporadic visual distortion. What is the MOST likely cause?

• A. Electromagnetic interference (EMI)
• B. Radio frequency interference (RFI)
• C. (EMC)
• D. Fast transients
• E. Electromagnetic discharge (ESD)

Answer: A

NEW QUESTION 7

A tapped trunk topology uses ______ cabling to support a DAS.

• A. Shielded twisted pair
• B. Balanced twisted pair
• C. Unbalanced twisted pair
• D. Optical fiber

Answer: D

NEW QUESTION 8

What element is typically NOT part of a paging system?

• A. Strobe
• B. Distribution
• C. Amplification
• D. Loudspeakers

Answer: A

NEW QUESTION 9

Within a heating ventilation and air conditioning automatic control system, what do the letters DDC stand for?

• A. Dual division charger
• B. Direct digital control
• C. Diverse duct center
• D. Direct drive cable
• E. Differential diffuser control

Answer: B

NEW QUESTION 10

Exhibit:

If a work breakdown structure (WBS) shows the tasks below, what is C, the successor task?
A) Install OSP pathways
B) Install fiber
C) ______.

• A. Hold inspection
• B. Create budget
• C. Conduct safety meeting
• D. Perform site survey

Answer: A

NEW QUESTION 11

The MINIMUM recommended lighting requirement in a telecommunications room (TR) at the point of cable terminations is:

• A. 150 lux
• B. 300 lux
• C. 500 lux
• D. 750 lux
• E. 1000 lux

Answer: C

NEW QUESTION 12

In a run requiring 15 m (50 ft) of cable between the floor distributor and the consolidation point, the MAXIMUM length of cable allowed between the CP and the telecommunications outlet is:

• A. 27.4 m (90 ft)
• B. 36.5 m (120 ft)
• C. 45.8 m (150 ft)
• D. 75 m (242 ft)
• E. 90 m (295 ft)

Answer: D

NEW QUESTION 13

In order to maximize its ability to send and receive, an antenna should be ______ to the desired frequency.

• A. Dipped
• B. Loaded
• C. Tuned
• D. Peaked

Answer: C

NEW QUESTION 14

What is the PERT estimate (in hours) for project design where:
- Optimistic time is 40 hours
- Most likely time is 50 hours
- Pessimistic time is 60 hours

• A. 40 hours
• B. 45 hours
• C. 50 hours
• D. 55 hours
• E. 60 hours

Answer: C

NEW QUESTION 15

You are designing a DAS that will support five buildings on a college campus. Which medium is best suited to ensure the best connectivity and throughput between the headend and backend devices located in the various buildings?

• A. Coaxial
• B. Optical fiber cabling
• C. Shielded twisted pair cabling
• D. Unshielded twisted pair cabling

Answer: B

NEW QUESTION 16
......