We provide real hpe6-a41 exam questions and answers braindumps in two formats. Download PDF & Practice Tests. Pass HP hpe6-a41 Exam quickly & easily. The hpe6-a41 PDF type is available for reading and printing. You can print more and practice many times. With the help of our HP hpe6-a41 dumps pdf and vce product and material, you can easily pass the hpe6-a41 exam.

Online HP hpe6-a41 free dumps demo Below:

NEW QUESTION 1
Refer to the exhibit.
HPE6-A41 dumps exhibit
Device 1 needs to send traffic to Device 2, and it sends an ARP request in preparation. Which devices process this ARP request?

  • A. all devices in VLAN 2, 192.168.2.0/24 subnet
  • B. all devices connected to Switch-2
  • C. all devices in VLAN 3, 192.168.3.0/24 subnet
  • D. all devices in this network

Answer: A

NEW QUESTION 2
Refer to the exhibit.
HPE6-A41 dumps exhibit
A network administrator wants to set up a link aggregation between two switches, as shown in the exhibit. The link aggregation must meet these requirements:
HPE6-A41 dumps exhibit Protects against misconfiguration
HPE6-A41 dumps exhibit Can be configured with VLANs and other settings Which type of link aggregation should the administrator create?

  • A. dynamic LACP
  • B. static LACP
  • C. manual (trunk)
  • D. distributed (trunk)

Answer: B

NEW QUESTION 3
What does the traceroute command that is entered on an ArubaOS switch identify?

  • A. each physical device between the switch and a destination
  • B. the path to each router connected to the switch
  • C. each Layer 3 device between the switch and a destination
  • D. debug output tracing entries to the routing table

Answer: C

NEW QUESTION 4
An ArubaOS switch operates at factory default settings. A network administrator enters this command:
Switch (config)# password operator plaintext mysecret
How does the switch now control access to the CLI through the console port?

  • A. It forces users to enter no username and password operator to gain access to basic mod
  • B. Users must then enter password mysecret to reach enable mode.
  • C. It forces users to enter username operator and password mysecret to gain access to basic mod
  • D. Users can then reach enable mode without authenticating.
  • E. It allows users to access basic mode without logging in, but forces them to enter password mysecret to reach enable mode.
  • F. It forces users to enter no username and password mysecret to gain access to basic mod
  • G. Users can then reach enable mode without authenticating.

Answer: C

NEW QUESTION 5
Refer to the exhibit.
HPE6-A41 dumps exhibit
Based on the output shown in this exhibit, which statement is true about the 10.0.0.2 neighbor?

  • A. The neighbor rejects communications because it already has its maximum number of neighbors.
  • B. The neighbor has mismatched settings and cannot exchange information with this switch.
  • C. The neighbor communicates with this switch, but it cannot hold any more routes in its database.
  • D. The neighbor communicates with this switch, and they have exchanged all topology information.

Answer: D

NEW QUESTION 6
Refer to the exhibit.
HPE6-A41 dumps exhibit
A network administrator logs in to the CLI of a Virtual Switching Framework (VSF) fabric and enters the command shown in the exhibit.
What does the output reveal?

  • A. MAD assistant at 10.1.0.2 failed to respond to probe requests.
  • B. The VSF link failed, and MAD shut down the links on the other member.
  • C. MAD is configured incorrectly and causes a split brain situation to occur.
  • D. The VSF link failed, and MAD shut down the links on this switch.

Answer: B

NEW QUESTION 7
A network administrator wants to form a cluster with several Aruba Instant APs. What is required to achieve this goal?

  • A. All APs must be pre-configured with WLANs with the same SSID.
  • B. All APs must be in the same regulatory domain.
  • C. All APs must operate on the same radio channel.
  • D. All APs must be the same model.

Answer: B

NEW QUESTION 8
A network administrator enters this command in an ArubaOS switch CLI:
Switch(config)# ip route 0.0.0.0/0
The CLI shows this error: Incomplete input: 0.0.0.0/0
How can the administrator find a valid way to complete the command?

  • A. Enter ip ––help route.
  • B. Enter ip route 0.0.0.0/0 ? with a space before the ?.
  • C. Enter help ip route.
  • D. Enter ip route 0.0.0.0/0? With no space before the ?.

Answer: B

NEW QUESTION 9
Member1 is the commander of a Virtual Switching Framework (VSF) fabric. A power distribution causes member 1 to go down. Now the network administrator wants to rejoin member1 to the VSF fabric and make member1 the commander again.
What should the administrator do?

  • A. Boot member1 and allow it to rejoin to the VSF fabri
  • B. Then reboot member2.
  • C. Boot member1 and allow it to rejoin the VSF fabric.
  • D. Disconnect member1 from member2 before booting member1.
  • E. Configure member2 with VSF priority0. Then boot member1 and allow it to rejoin the VSF fabric.

Answer: D

NEW QUESTION 10
What is true about the community string used for SNMPv1 and SNMPv2c?

  • A. The community string hashes the SNMP message, but does not encrypt it, which provides for data integrity.
  • B. The community string is like a password transmitted in cleartext, which provides no data integrity or privacy.
  • C. The community string encrypts the SNMP message, but does not hash it, which provides for data privacy.
  • D. The community string encrypts and hashes the SNMP message, which provides for data integrity and privacy.

Answer: B

NEW QUESTION 11
Which type of 802.11 wireless network can be hosted by an endpoint device such as a laptop?

  • A. a wireless distribution system
  • B. an ad hoc network
  • C. a wireless mesh or bridge
  • D. an infrastructure network

Answer: B

NEW QUESTION 12
A network administrator uses the console to access an ArubaOS core switch and wants to find the management IP address of another ArubaOS switch that is currently connected to port B1. Which information should the administrator review?

  • A. interface with the use of the show interface command
  • B. LLDP with the use of the show lldp info remote-device command
  • C. ARP with the use of the show arp command
  • D. device profile with the use of the show device-profile status command

Answer: B

NEW QUESTION 13
Which ArubaOS switch feature treats multiple ports as one logical port?

  • A. OSPF
  • B. STP
  • C. VSF
  • D. link aggregation

Answer: D

NEW QUESTION 14
What is a valid setup for a Virtual Switching Framework (VSF) fabric?

  • A. one 5406R zl2 switch as commander and one 5412R zl2 switch as a standby member
  • B. one 5412R zl2 switch as commander and two 5406R zl2 switches as standby members
  • C. one 5406R zl2 switch as commander and two 5412R zl2 switches as standby members
  • D. one 5412R zl2 switch as commander and one 5412R zl2 switch as a standby member

Answer: D

NEW QUESTION 15
Refer to the exhibit.
HPE6-A41 dumps exhibit
What should the network administrator do to permit Switch-1 to route traffic from a client in 10.1.11.0/24 to a client in 10.1.12.0/24?

  • A. Enable proxy ARP.
  • B. Enable IP routing.
  • C. Configure a static route to 10.1.11.0/24 and a static route to 10.1.12.0/24.
  • D. Enable OSPF routing on VLAN 11 and on VLAN 12 in the same area.

Answer: B

NEW QUESTION 16
Refer to the exhibit.
HPE6-A41 dumps exhibit
Assume that Student A’s ARP table is empty. Student A prepares to send an FTP packet to FTP Server B and needs to discover the proper destination MAC address.
For which IP address does Student A send an ARP request?

  • A. 10.1.2.2
  • B. 10.1.10.1
  • C. 10.1.10.87
  • D. 10.1.20.1

Answer: D

NEW QUESTION 17
A company wants a modular switch for the core layer of its mid-sized campus. The switch requires 32 10 G ports in a single switch with the ability to scale in the future. Which ArubaOS switches series is best suited for this role?

  • A. Aruba 2930F
  • B. Aruba 3800
  • C. Aruba 3810
  • D. Aruba 5400R

Answer: A

NEW QUESTION 18
Which standard for wireless connectivity supports both 2.4GHz and 5GHz?

  • A. 802.11a
  • B. 802.11ac
  • C. 802.11g
  • D. 802.11n

Answer: D

NEW QUESTION 19
Refer to the exhibit.
HPE6-A41 dumps exhibit
Which feature should the network administrator configure on the Virtual Switching Framework (VSF) fabric to prevent issues if Links 1 and 2 fail?

  • A. Graceful OSPF (non-stop forwarding)
  • B. Multi-Active Detection (MAD)
  • C. Distributed trunking
  • D. Virtual Router Redundancy Protocol (VRRP)

Answer: B

NEW QUESTION 20
A Virtual Switching Framework (VSF) fabric is configured to use LLDP-MAD.
Which action does the standby member take if it sends a probe but receives no response?

  • A. It sends a request packet to the commander to determine which ports should remain active.
  • B. It continues to function and assumes the role of commander.
  • C. It automatically changes its status to MAD inactive fragment.
  • D. It requests that the commander change its status to MAD inactive fragment.

Answer: A

NEW QUESTION 21
Several servers are connected to an ArubaOS switch. The servers send traffic with 802.1Q VLAN ID 5. How should the network administrator configure the ArubaOS switch to receive this traffic?

  • A. Make VLAN 5 the Default VLAN on the switch before the servers connect to their switch ports.
  • B. Make switch ports connected to servers untagged members of VLAN 5.
  • C. Make switch ports connected to servers tagged members of VLAN 5.
  • D. Make VLAN 5 the Primary VLAN on the switch.

Answer: C

NEW QUESTION 22
A company has a single routing protocol environment.
What is one reason to use OSPF routing instead of static routing?

  • A. OSPF allows ArubaOS switches to use default routes, while static routes cannot use 0.0.0.0/0 as the destination network.
  • B. OSPF has a lower default administrative distance than static routing on ArubaOS switches.
  • C. OSPF reduces the risk of accidentally introducing routing loops, while static routing does not.
  • D. OSPF permits load sharing traffic over multiple routes, while static routing does not.

Answer: C

NEW QUESTION 23
Which benefit does Aruba Clarity in Aruba AirWave provide?

  • A. It provides an easily searchable network topology that includes physical wired, physical wireless, and virtual network infrastructure devices.
  • B. It helps managers use the AirWave Management Platform (AMP) with its context-specific help and links to additional resources.
  • C. It enables managers to view all configuration templates for APs, and switches from a single dashboard.
  • D. It provides at-a-glance views of issues such as DHCP request and 802.1X authentication failures to aidin troubleshooting.

Answer: A

NEW QUESTION 24
Refer to the exhibit.
Exhibit 1.
HPE6-A41 dumps exhibit
Exhibit 2.
HPE6-A41 dumps exhibit
HPE6-A41 dumps exhibit
Exhibit 3.
HPE6-A41 dumps exhibit
HPE6-A41 dumps exhibit
How many MSTP regions exist in the topology shown in the exhibit?

  • A. one
  • B. two
  • C. three
  • D. four

Answer: B

NEW QUESTION 25
......

Thanks for reading the newest hpe6-a41 exam dumps! We recommend you to try the PREMIUM DumpSolutions.com hpe6-a41 dumps in VCE and PDF here: https://www.dumpsolutions.com/hpe6-a41-dumps/ (125 Q&As Dumps)