Accurate of ccna wireless 200 355 official cert guide pdf free download free practice test materials and testing engine for Cisco certification for IT engineers, Real Success Guaranteed with Updated 200 355 pdf pdf dumps vce Materials. 100% PASS Implementing Cisco Wireless Network Fundamentals exam Today!
Q161. Which description best describes upfade in a multipath environment?
A. In this situation, multiple signal paths are not sent at exactly the same time. The receiver receives a positive crest on the primary signal and a negative crest on the secondary signal.
B. In this situation, the multiple signal paths are distorted and difficult to understand.
C. In this situation, the multiple signal paths are weaker than they should be because the signals are out of phase with each other.
D. In this situation, the signal is stronger than it should be because multiple signal paths are received twice at exactly the same time, which results in the multiple signals being in-phase.
Answer: D
Q162. Access points must discover a wireless LAN controller before they can become an active part of the network. In which order does an access point try to discover a controller?
A. Layer 3 CAPWAP or LWAPP broadcast discovery DHCP option 43 Locally stored controller IP address discovery DNS controller name resolution
B. Layer 3 CAPWAP or LWAPP broadcast discovery Locally stored controller IP address discovery DNS controller name resolution DHCP option 43
C. Layer 3 CAPWAP or LWAPP broadcast discovery Locally stored controller IP address discovery DHCP option 43 DNS controller name resolution
D. DNS controller name resolution DHCP option 43 Layer 3 CAPWAP or LWAPP broadcast discovery Locally stored controller IP address discovery
Answer: C
Q163. What are three primary components that describe TKIP? (Choose three.)
A. broadcast key rotation
B. dynamic WEP
C. message integrity check
D. per-packet key hashing
E. symmetric key cipher
F. WPA2 enterprise mode
Answer: A,C,D
Q164. Refer to the exhibit. An engineer is configuring a SSID to utilize the management interface on the WLC. The management interface is configured with an untagged VLAN in the wireless controller interface settings. The controller is connected to a neighboring switch via the interface shown in the diagram.
Which VLAN will traffic coming from the newly created SSID use to traverse the wired network?
A. 1
B. 20
C. 44
D. 50
Answer: C
Q165. Which interface is used to connect the foreign and anchor controllers?
A. management
B. service
C. virtual
D. dynamic
Answer: A
Q166. Refer to the exhibit.
What does the yellow shield with the exclamation mark indicate?
A. The network uses open authentication and no encryption.
B. The network uses an unsupported channel.
C. The signal is too distorted to connect.
D. The AP that is transmitting this SSID uses the wrong RF domain.
E. This is the ad-hoc network.
Answer: A
Q167. Refer to the exhibit. An engineer wants to setup a mobility anchor for the Guest WLAN, but does not see the Anchor IP address listed in the drop-down. What is the most likely cause of this problem?
A. The mobility anchor is currently unreachable.
B. The mobility anchor must also be included in the mobility group of the WLC.
C. Layer 3 Security must be configured for Web Policy Authentication.
D. The mobility anchor is attached to another WLAN.
E. Layer 3 Security must be configured for Web Policy Passthrough.
Answer: B
Q168. Which Cisco AnyConnect module provides wireless connectivity?
A. telemetry
B. web security
C. VPN
D. NAM
E. DART
F. posture
G. CSSC
Answer: D
Q169. What are two security threats to wireless networks? (Choose two.)
A. ad-hoc networks
B. client misassociation
C. port redirection
D. cross-site scripting
Answer: A,B
Q170. What are three characteristics of the 802.11g standard? (Choose three.)
A. speed of as much as 11 Mb/s
B. speed of as much as 54 Mb/s
C. backward-compatibility with 802.11a
D. backward-compatibility with 802.11b
E. OFDM as an additional modulation technique
F. OFDM and CCK as additional modulation techniques
Answer: B,D,E