Questions Ask for 9tut ccnp 300 101

Q1. Which IPV6 address type does RIPng use for next-hop addresses?

A. anycast

B. global

C. multicast

D. site-local

E. link-local

Q2. Which alerts will be seen on the console when running the command: logging console warnings.?

A. warnings only

B. warnings, notifications, error, debugging, informational

C. warnings, errors, critical, alerts, emergencies

D. notifications, warnings, errors

E. warnings, errors, critical, alerts

Q3. Refer to the exhibit.

Which command would verify if PBR reacts to packets sourced from 172.16.0.0/16?

A. show ip route

B. show policy-map

C. show access-lists

D. show route-map

Q4. Refer to Exhibit.

A senior network engineer tries to propagate a summary route 209.165.201.0/27 to R2 by redistributing static route on R1, but setup is not working. What is the issue with the configuration in the exhibit.

A. The summary route is in the global routing table.

B. The wildcard bit in network command is incorrect.

C. The redistribute command is in the wrong address-family.

D. The route target is missing.

Q5. Which two statements about NHRP in a DMVPN environment are true? (Choose two )

A. It can authenticate VPN endpoints.

B. It can identity PIM-SM RPs over a tunnel.

C. It routes traffic through the tunnel.

D. It provides address resolution to route traffic

E. It requires each endpoint to have a unique network ID.

Q6. Which three benefits does the Cisco Easy Virtual Network provide to an enterprise network? (Choose three.)

A. simplified Layer 3 network virtualization

B. improved shared services support

C. enhanced management, troubleshooting, and usability

D. reduced configuration and deployment time for dot1q trunking

E. increased network performance and throughput

F. decreased BGP neighbor configurations

Q7. Refer to the exhibit. What two statements are true? (Choose two.)

A. Interface FastEthernet 0/0 was configured with the ipv6 ospf 1 area 1 command.

B. OSPF version 2 has been enabled to support IPv6.

C. The IP address of the backup designated router (BDR) is FE80::205:5FFF:FED3:5808.

D. The output was generated by the show ip interface command.

E. The router was configured with the commands: router ospf 1 network 172.16.6.0

0.0.0.255 area 1

F. This is the designated router (DR) on the FastEthernet 0/0 link.

Q8. A network administrator notices that the BGP state drops and logs are generated for missing BGP hello keepalives. What is the potential problem?

A. Incorrect neighbor options

B. Hello timer mismatch

C. BGP path MTU enabled

D. MTU mismatch

Q9. A policy needs to be implemented on Router B so that any traffic sourced from 172.16.10.0/24 will be forwarded to Router C.

Which configuration on Router B will achieve the desired effect?

A. access-list 1 permit 172.16.10.0 0.0.0.255!interface s0ip policy route-map policy!route-

map policy permit 10match ip address 1set ip next-hop 172.16.12.3

B. access-list 1 permit 172.16.10.0 0.0.0.255!interface e0ip policy route-map policy!route- map policy permit 10match ip address 1set ip next-hop 172.16.12.2

C. access-list 1 permit 172.16.10.0 0.0.0.255!interface e0ip policy route-map policy!route- map policy permit 10match ip address 1set ip next-hop 172.16.14.4

D. access-list 1 deny 172.16.10.0 0.0.0.255!interface s0ip policy route-map policy!route- map policy permit 10match ip address 1set ip next-hop 172.16.12.2

Q10. Refer to the exhibit. Which statement about the configuration is true?

A. 20 packets are being sent every 30 seconds.

B. The monitor starts at 12:05:00 a.m.

C. Jitter is being tested with TCP packets to port 65051.

D. The packets that are being sent use DSCP EF.