Pass4sure offers free demo for ccie 400 101 exam. "CCIE Routing and Switching (v5.0)", also known as cisco 400 101 exam, is a Cisco Certification. This set of posts, Passing the Cisco passleader 400 101 exam, will help you answer those questions. The 400 101 ccie Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco ccie 400 101 dumps exams and revised by experts!

P.S. Free 400-101 prep are available on Google Drive, GET MORE: https://drive.google.com/open?id=1TSHirf5GcSZMtvxszMH308yqhbZPjOHA


New Cisco 400-101 Exam Dumps Collection (Question 15 - Question 21)

Q15. Which metric vectors are stored but are not used by default in EIGRP?

A. Reliability and delay

B. Bandwidth and delay

C. Load and reliability

D. Load and bandwidth

Answer: C


Q16. Which topology allows the split-horizon rule to be safely disabled when using EIGRP?

A. Hub and spoke

B. Ring

C. Full mesh

D. Partial mesh

Answer: A


Q17. Refer to the exhibit.

All routers are running EIGRP and the network has converged. R3 and R4 are configured as EIGRP stub. If the link between R1 and R3 goes down, Which statement is true?

A. R3 does not advertize 192.168.0.0/24 to R4 anymore.

B. R2 does not have a route to 192.168.0.0/24 in the routing table.

C. The prefix 192.168.0.0/24 becomes stuck-in-active on R4.

D. R1 sends traffic destined to 192.168.0.100 via R2

Answer: B


Q18. Two routers are connected on a PPP link using CHAP authentication by default which value will

the routers use as t identification on the link?

A. Their host names

B. Their IP address on the connected link

C. Their interface numbers

D. Their serial numbers

Answer: A


Q19. In which way does the Bridge Assurance mechanism modify the default spanning-tree behavior

in an effort to prevent bridging loops?

A. IF BPDUs are no longer received on a port, the switch immediately sends a out a TCN BPDU.

B. Extended topology information is encoded into all BPDUs.

C. BPDUs are sent bidirectional on all active networks ports, including blocked and alternate ports.

D. Received BPDUs are looped back toward the sender to ensure that link is bidirectional.

Answer: C


Q20. Which 1ype of ACL can be applied only to Layer 2 ports?

A. Reflexive ACLs

B. VLAN ACLs

C. Standard ACLs

D. PortACLs

E. Dynamic ACLs

Answer: D


Q21. Refer to the exhibit.

Which tag will be applied to 172.16.50.0/24 route?

A. 10

B. 20

C. 11

D. 40

Answer: A


100% Most recent Cisco 400-101 Questions & Answers shared by Thedumpscentre, Get HERE: http://www.thedumpscentre.com/400-101-dumps/ (New 427 Q&As)