Our pass rate is high to 98.9% and the similarity percentage between our route 300 101 study guide and real exam is 90% based on our seven-year educating experience. Do you want achievements in the Cisco 9tut ccnp 300 101 exam in just one try? I am currently studying for the Cisco ccnp 300 101 exam. Latest Cisco 300 101 route Test exam practice questions and answers, Try Cisco ccnp route 300 101 pdf Brain Dumps First.
P.S. Accurate 300-101 keys are available on Google Drive, GET MORE: https://drive.google.com/open?id=1g3xBE0KhVLL-l1SXbBZMbJhQ4SK2THNQ
New Cisco 300-101 Exam Dumps Collection (Question 12 - Question 21)
Question No: 12
What are two limitations when in use of NPTv6 for IPV6 vs IPV6 Address translation?
A. stateful address translation
B. a limit of 32 1-to-1 translations
C. lack of overloading functionality
D. identify all interfaces NAT inside or outside
E. 1-to-1 prefix rewrite
F. mismatched prefix allocations
Answer: C,E
Question No: 13
Which type of access list allows granular session filtering for upper-level protocols?
A. content-based access lists
B. context-based access-lists
C. reflexive access-lists
D. extended access lists
Answer: D
Question No: 14
You have been asked to evaluate how EIGRP is functioning in a customer network.
What is the advertised distance for the 192.168.46.0 network on R1?
A. 333056
B. 1938688
C. 1810944
D. 307456
Answer: A
Question No: 15
Refer to the exhibit.
After configuring the routes, the network engineer executes the show ip route command. What is the expected results?
A. Gateway of last resort is 10.0.2.1 to network 0.0.0.0 10.0.0.0/24 is subnetted, 2 subnetsC 10.0.2.0 is directly connected, FastEthernet0/0 10.0.1.0 is directly connected, FastEthernet0/1S"0.0.0.0/0 [1/0] via 10.0.2.1(1/0] via 10.0.1.1Router#
B. Gateway of last resort is 10 0.2 1 to network 0 0 00 10 0.0 0/24 is subnetted, 1 subnet C
10.0.2 is directly connected, FastEthernet 0/0 Su201d 0.0.0 0/0 [1/0] via 10.0.2.1 Router #
C. Gateway of last report is not setRouter #
D. Gateway of test resort is 10.0.1.1 to network 0.0.0.0 10.0.0.0/24 is subnetted 1 subnet C
10.0.1.0 is directly connected FastEthernet0/1 Su201d 0.0.0.0/0 [1/0] via 10.0.1.1 Router #
Answer: C
Question No: 16
PPPoE is composed of which two phases?
A. Active Authentication Phase and PPP Session Phase
B. Passive Discovery Phase and PPP Session Phase
C. Active Authorization Phase and PPP Session Phase
D. Active Discovery Phase and PPP Session Phase
Answer: D
Question No: 17
Refer to the exhibit.
A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up.
What did the TAC engineer configure incorrectly?
A. The crypto isakmp configuration is not correct.
B. The crypto map configuration is not correct.
C. The interface tunnel configuration is not correct.
D. The network configuration is not correct; network 172.16.1.0 is missing.
Answer: A
Question No: 18
A network engineer configures two connected routers to run OSPF in Area 0; however, the routers fail to establish adjacency. Which option is one of the caused for this issue?
A. Area numbers match.
B. OSPF process numbers do not match on both neighbor routers.
C. The Same MTU sizes are configured on both sides.
D. The Same OSPF router IDs are configured on both routers.
Answer: B
Question No: 19
Which cisco Express Forwarding component maintains Layer 2 addressing information?
A. dCEF
B. adjacency table.
C. FIB
D. fast switching
E. RIB
Answer: B
Explanation: Adjacency TablesNodes in the network are said to be adjacent if they can reach each other with a single hop across a link layer. In addition to the FIB, CEF uses adjacency tables to prepend Layer 2 addressing information. The adjacency table maintains Layer 2 next-hop addresses for all FIB entries. http://www.cisco.com/c/en/us/td/docs/ios/12_2/switch/configuration/guide/fswtch_c/xcfcef.ht ml
Question No: 20
Which three characteristics are shared by subinterfaces and associated EVNs? (Choose three.)
A. IP address
B. routing table
C. forwarding table
D. access control lists
E. NetFlow configuration
Answer: A,B,C
Topic 5, Infrastructure Security
53.For troubleshooting purposes, which method can you use in combination with the u201cdebug ip packetu201d command to limit the amount of output data?
A. You can disable the IP route cache globally.
B. You can use the KRON scheduler.
C. You can use an extended access list.
D. You can use an IOS parser.
E. You can use the RITE traffic exporter.
Question No: 21
A network engineer has left a NetFlow capture enabled over the weekend to gather information regarding excessive bandwidth utilization. The following command is entered:
switch#show flow exporter Flow_Exporter-1 What is the expected output?
A. configuration of the specified flow exporter
B. current status of the specified flow exporter
C. status and statistics of the specified flow monitor
D. configuration of the specified flow monitor
Answer: B
100% Regenerate Cisco 300-101 Questions & Answers shared by Allfreedumps, Get HERE: https://www.allfreedumps.com/300-101-dumps.html (New 487 Q&As)