Testking 9L0-009 Questions are updated and all 9L0-009 answers are verified by experts. Once you have completely prepared with our 9L0-009 exam prep kits you will be ready for the real 9L0-009 exam without a problem. We have Avant-garde Apple 9L0-009 dumps study guide. PASSED 9L0-009 First attempt! Here What I Did.
Q1. Apple Service Toolkit uses ____ to check Macs with Mac Resource Inspector and other diagnostic utilities.
A. NetBoot
B. Open Firmware
C. Target Disk Mode
D. Apple Remote Desktop
Answer: A
Q2. Which of the following is a valid precaution you should take when you begin working inside a MacBook Pro (13-inch, Mid 2010)?
A. Reset the SMC.
B. Remove the hard drive.
C. Disconnect the optical drive.
D. Disconnect the main battery.
Answer: D
Q3. You are removing the main battery from a MacBook Pro (17-inch, Early 2009). Which of the following is a best practice when handling this battery?
A. Handle the battery with one hand, pressing between the soft side and the hard side.
B. Re-cover any punctures or tears in the soft mylar covering with Kapton tape.
C. Handle the battery any way; it does not matter.
D. Hold the battery carefully by its edges only.
Answer: D
Q4. Examine the exhibit.
This specialized tool is required for the removal of which component from the Mac mini (Mid 2010)?
A. Fan
B. Memory
C. Bottom Cover
D. Antenna Plate
E. Logic Board Assembly
Answer: E
Q5. The Mac Pro (Early 2009) has SMC functionality split between a primary SMC on the backplane board, and a secondary SMC on the processor board. What service issue should a technician be aware of when servicing the Mac Pro (Early 2009)?
A. SMC firmware must always match on both boards.
B. Three internal buttons must be pressed in order to reset both SMCs.
C. It is required to remove the memory riser card in order to reset the SMC.
D. Processor trays are interchangeable between similar Mac Pro (Early 2009) units.
Answer: A
Q6. What is the proper way to calibrate the main battery in a MacBook?
A. Charge the battery while running the Battery Calibration Utility.
B. The battery is calibrated out of the box; no further steps are needed.
C. Charge the battery overnight. Make sure battery status indicates 100% before disconnecting AC adapter.
D. Charge the battery fully. Wait 2 hours. Run the MacBook on battery until it goes to sleep. Wait 5 hours. Charge it fully again.
E. Charge the battery halfway. Wait 2 hours. Finish charging the battery. Run the MacBook on battery until it goes to sleep. Charge it fully
again.
Answer: D
Q7. What step is required before upgrading the RAM in a Mac Pro (Early 2009)?
A. Remove the processor tray.
B. Remove the hard drive carriers.
C. Remove the front inlet fan assembly.
D. Remove the Optical Drive and Carrier.
Answer: A
Q8. A customer asks if there is a diagnostic that he can use to help troubleshoot a hardware problem with his MacBook Pro. Which of the following solutions should you suggest?
A. Apple Service Diagnostic
B. Apple Hardware Test
C. Terminal
D. Console
Answer: B